Tuning Wiki

Pads turn the car's kinetic energy into heat, and how well they do that depends on how hot they are. This page covers the pad side of fade. The fluid side is on brake fluid, boiling points and brake fade. The sources used here are general magazine and parts-maker guidance, and the data sheet for a specific pad should be preferred over any general statement below.

Friction depends on temperature

A pad's friction coefficient changes with its operating temperature. A pad performs as intended only inside its design temperature window, and outside it the braking can be unpredictable or unsafe (DSPORT: Braking 101). Makers usually publish this as a curve: friction rises as the pad warms, stays roughly level across the working range, then falls if the pad overheats. That fall is fade from the pad. Fade from boiling fluid is a different mechanism, and one car can suffer both.

Pad families

Pads are grouped by material: organic, semi-metallic, sintered metallic, ceramic composite, carbon composite and carbon-metallic composite. The trade-offs, in general terms:

  • Original-equipment pads are designed for low cost, low noise and long life. Hard braking on a track or in spirited driving is marginal for them, and fade can be experienced.
  • Street performance pads improve fade resistance with more expensive materials, and some reduce dust.
  • Racing pads offer better performance at high temperature, with shorter pad and rotor life, more dust and more noise. They are usually less effective when cold, so they suit use where the brakes are brought up to temperature.

The right pad is one matched to the car's use. A road car that is driven mostly cold is poorly served by a race pad, and a track car is poorly served by an original-equipment pad.

Bedding

New pads are bedded in to lay down an even transfer layer on the rotor. The bedding temperature should be similar to the pad's operating range, and the pad maker's procedure should be followed. New rotor metal that has never been heat cycled can be too soft, so some manufacturers advise against bedding pads on a brand-new rotor (DSPORT). Follow the pad and rotor maker's combined instructions.

Choosing and checking

  1. Decide the use first: road only, mixed road and track, or competition. See planning a performance engine build.
  2. Use pads whose data sheet states the friction range and temperature window, and that suit the rotor.
  3. Change the fluid and check the hydraulic system at the same time: brake fluid.
  4. Bed the pads in the maker's way, then test the brakes progressively in a safe place before relying on them.
  5. Inspect pad and rotor wear, glazing and cracking regularly, especially after hard use.

This wiki does not yet cover rotor design, calipers or brake cooling in depth, and does not make claims about drilled or slotted rotors. Brake work is safety-critical and should be done to the maker's procedure by a competent person. For the electronic side of the system see ABS failures, warning lights and fault diagnosis. Stronger braking also loads the tyres and suspension: power, weight and traction.

Sources