Tuning Wiki

BMW Scanner, usually called PA Soft 1.4, is a third-party Windows program and matching USB interface for module access on older BMW chassis. It is not ISTA, INPA or a current dealer tester. The program and the dongle belong together: sellers state that the 1.4 software does not run on an ordinary K+DCAN cable. Interfaces sold today come from independent shops. The photograph below is one seller's current interface, not a picture of every unit that has been sold under this name. [1]

Four views of a USB OBD interface sold for PA Soft
USB interface sold with PA Soft 1.4 by BMW SCANNER PASOFT. Photograph © that seller. Reproduced for identification and review, with acknowledgement. Source: BMW PASOFT scanner kit, accessed 11 November 2026.

Chassis the seller lists

That seller's kit page names full use, subject to what each module actually offers, on E46, E39, E38, E53, E83, E85 and E52. E36 and E34 are listed with a 20-pin adapter, and E34 support is described as limited. Earlier E38 and E39 cars with the round 20-pin socket under the bonnet need that adapter; later cars in those series use the 16-pin socket. [1] BMW diagnostic connections covers the socket choice.

Functions described by the seller

  • Identification of chassis, engine, gearbox and equipment, and a scan of modules for fault codes.
  • Live data on stated control units, including DME MS43.0, EWS3 and the airbag module in the seller's examples.
  • Reading and saving EEPROM, program memory and coding data, and restoring a backup.
  • Copying ZCS and FA coding between the stated modules, and an EWS to DME synchronisation on DME MS43.0.
  • Key status in EWS3, including the ability to see which key positions are present.

The seller's setup guide also refers to screens that change stored vehicle data, including an odometer option inside DME programming. Those steps are not repeated here. See mileage programmers before considering any recorded-distance function. [2]

Where it still earns a place

On these chassis, PA Soft is used for a module list, coding backup and simple EWS and DME jobs without loading DIS or ISTA. It does not replace BimCOM or ISTA on later cars, and it does not program F, G or later control units. Windows 10 and 11 need the seller's driver arrangement, which that shop says requires driver-signature enforcement to be turned off for installation. Treat unofficial copies and unlabelled dongles as unknown: the interface and the software build have to match. [1]

Related pages

Specialist BMW diagnostic tools · SECONS BimCOM · BMW DIS diagnostic software · BMW NCS Expert

Sources

Seller pages accessed 11 November 2026. The original developer of PA Soft 1.4 is not identified on these shop pages, so this article does not attribute the software copyright to the current seller. The photograph is the seller's.