Tuning Wiki
Browse AiM

Solo 2 DL is a GPS lap timer and logger with an ECU connection and AiM expansion port. The DL variant differs electrically from the standard Solo 2. For the range overview see AiM in-car dataloggers.

AiM Solo 2 DL
AiM Solo 2 DL. Image: AiM, reproduced with permission; AiM product picture library.

Specifications

ItemSpecification
GNSS and motion25 Hz GNSS; internal three-axis accelerometer and gyroscope
Display238 × 99 graphical display; up to eight configurable pages
ECU connectionCAN, RS232 or K-Line, depending on selected cable and ECU
Memory / power4 GB internal; rechargeable lithium battery; 9–15 V external
Connectors5-pin EXP plus 8-pin ECU Binder 712; IP67

Specifications and kit contents: AiM AiM Solo 2 DL technical documentation. Check hardware generation and exact kit.

Pinout

AiM's diagrams show the Binder 712 female connectors in external device view. The standard Solo 2 uses different EXP assignments.

Expansion, 5-pin Binder 712 female

PinFunction
1CAN high / CAN+ expansion
2Ground
3+Vb out
4CAN low / CAN− expansion
5+Vb external

ECU, 8-pin Binder 712 female

PinFunction
1CAN ECU+
2CAN ECU−
3+Vb external
4ECU RS232 TX
5ECU RS232 RX
6K-Line
7Ground
8RPM

Wiring and installation

Solo 2 DL socket faces, numbered external device view
Solo 2 DL socket faces, numbered external device view; original Tuning Wiki illustration based on AiM documentation. Schematic diagrams do not show physical connector positions unless explicitly labelled.
Solo 2 DL and XLog connection paths
Solo 2 DL and XLog connection paths; original Tuning Wiki illustration based on AiM documentation. Schematic diagrams do not show physical connector positions unless explicitly labelled.

AiM lists CAN/K-Line OBD-II, CAN/RS232 and RPM/external-power leads for this model. Choose the exact protocol and lead; the EXP network can support compatible AiM modules. Check power requirements for the selected kit.

Choose the correct model-specific lead and configure the ECU protocol in Race Studio 3. A connector shape alone does not establish vehicle compatibility. Confirm every cavity number, signal level, ground, power source and electrical limit in the linked AiM documentation before wiring; diagrams are from the device view or a conceptual schematic as stated. Secure the loom and make connections with power disconnected.

Software and further reading

Race Studio 3 Analysis example showing suspension traces; actual channels depend on the device and connected sensors
Race Studio 3 Analysis example showing suspension traces; actual channels depend on the device and connected sensors. Image: AiM, reproduced with permission; manufacturer source.

Analysis and download: AiM supports reviewing Solo 2 DL recordings in Race Studio 3. ECU data appears only when a supported ECU, protocol and cable are connected and configured. AiM model guidance. Download the Windows software from AiM Race Studio 3 software downloads. For capabilities and compatibility see AiM data-log analysis software.

Use AiM Race Studio 3 to configure supported devices and analyse recorded sessions. Check the specific ECU protocol and cable before connection; not every source exposes every channel. Manufacturer references: model documentation; product and installation guidance.