Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Diagnostics
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Changes from revision 1 to revision 1

Removed text is struck through; added text is highlighted.

Start by recording the symptom and the conditions that produce it. Identify the vehicle, engine and control unit before using a fault-code description or a test specification.

From symptom to test

Record fault codes and any freeze-frame or live data before clearing them. Use the conditions in the record to plan the next check.Compare the relevant measurements with the vehicle-specific procedure. A fault code identifies a condition the controller detected. Use measurements to confirm the cause.After a repair, repeat the conditions that produced the fault and check the result.

Choose the vehicle or manufacturer below for system-specific references. The scan-tool directory and guide to diagnostic equipment cover different ways to collect evidence.

Rendered revisions

Open each version to inspect formatting, tables and photographs.

Revision 1: Diagnostics overview

Start by recording the symptom and the conditions that produce it. Identify the vehicle, engine and control unit before using a fault-code description or a test specification.

From symptom to test

  1. Record fault codes and any freeze-frame or live data before clearing them. Use the conditions in the record to plan the next check.
  2. Compare the relevant measurements with the vehicle-specific procedure. A fault code identifies a condition the controller detected. Use measurements to confirm the cause.
  3. After a repair, repeat the conditions that produced the fault and check the result.

Choose the vehicle or manufacturer below for system-specific references. The scan-tool directory and guide to diagnostic equipment cover different ways to collect evidence.

Revision 1: Diagnostics overview

Start by recording the symptom and the conditions that produce it. Identify the vehicle, engine and control unit before using a fault-code description or a test specification.

From symptom to test

  1. Record fault codes and any freeze-frame or live data before clearing them. Use the conditions in the record to plan the next check.
  2. Compare the relevant measurements with the vehicle-specific procedure. A fault code identifies a condition the controller detected. Use measurements to confirm the cause.
  3. After a repair, repeat the conditions that produced the fault and check the result.

Choose the vehicle or manufacturer below for system-specific references. The scan-tool directory and guide to diagnostic equipment cover different ways to collect evidence.