Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Tuning
Parent
Simos 8.5
Applies to
Simos 8.5
Tool groups
None
Manufacturers
None

This reference examines torque-related labels in the publicly indexed S85L1031_C2_e.a2l definition. The file describes itself as an enriched Simos 8.5 TFSI project with structure L10 and EPK S85L100. Its provenance, rights, completeness and match to a particular ECU or binary have not been independently verified. These are descriptions in one definition, not measured values or a validated execution trace.

Transmission and drive-mode limit labels

The file defines ip_tq_pow_max_at[0][0] as a maximum allowed clutch-torque map for automatic transmission types, and ip_tq_pow_max_mt[0][0] as a corresponding manual-transmission map. Both definitions refer to axes named n and gear; the file’s measurement descriptions identify those inputs as engine speed and a common gear quantity. The file also defines ip_tq_pow_max_spt[0] as a maximum clutch-torque map for sport mode, again with speed and gear inputs.

Those labels show that the definition contains distinct candidates for different configurations or modes. They do not establish which table a particular car selects, whether another limiter is lower, how a gear is encoded, or whether a numerical change alters delivered torque. Array indices alone do not identify a vehicle configuration. The A2L supplies definition metadata; it does not supply the calibration values from a particular vehicle.

Monitoring and fault-related examples

A different definition, ip_fac_tq_req_driv_dct_mon, is described as a scaling factor for requested clutch torque for a dual-clutch transmission. Its axis references are n_32_mon, described as engine speed at a monitoring level, and pv_av_mon, described as the monitoring-level accelerator-pedal activation. The name and axis descriptions provide an investigation lead; they do not establish how a monitoring function intervenes or prove that it is active in the software being logged.

The same file describes ip_tq_pow_max_cam_in as a clutch-torque maximum associated with an erroneous inlet cam position and links its axis to engine speed. That description illustrates why a torque-related limit may be associated with a fault condition; it does not identify a fault on any vehicle or justify changing the limit. Diagnose relevant cam, intake and control faults using the applicable workshop information before attributing a torque deficit to calibration.

Using the definitions

  1. Record the ECU part number, diagnostic and file software identifiers, transmission, drive mode, fuel and modifications. Check the provenance and permitted use of any definition; a matching-looking label or directory name is not proof of compatibility.
  2. Confirm the binary and definition are for the same software, then check the conversion, units, axes, table boundaries and operating-mode selection. Do not transfer symbols, values or assumptions to another Simos 8.5 revision or to Simos 8.4 without verification.
  3. When supported and correctly defined, compare requested and limited torque, gear, pedal and relevant measured engine behaviour under repeatable conditions. ECU torque quantities are estimates or requests, not an independent measurement of delivered torque. A table description alone cannot show which limit is active.

For the related supercharger and air-path definitions in this same unverified source, see Simos 8.5. For a separate custom feature, see Simos 8.5 Main Patch map switching; its slot maps are specific to that patch and must not be confused with proof of stock table selection.

Source and verification scope

Publicly indexed S85L1031_C2_e.a2l: project metadata, characteristic descriptions, axis references and measurement descriptions reviewed 17 November 2026. Retrieved file SHA-256: 2ed20a98b9b55d41347a6b125304aa28c52d2cd955a5e760ee049503a5c88f4b. This identifies the examined text only; it does not verify authenticity, rights, matching calibration values or runtime behaviour.