Simos 4S is an early Volkswagen Group petrol engine-management designation. A Volkswagen Passat workshop manual shows separate Simos 4S and 4S2 identification examples for particular engines, while VW's 1995 throttle-control training programme shows a Simos 4S diagnostic display. These are scoped examples rather than a complete fitment list. Record the actual ECU part number, system designation, program level and coding before choosing a diagnostic or calibration definition.
Documented identification examples
The VW Passat Simos workshop procedure shows a Simos 4S diagnostic identification example under engine codes ADY and AGG, and a Simos 4S2 example under AFT. The manual distinguishes the controller part number, system designation, program level and coding in the tester display. Its reproduced AFT example gives inconsistent program-level numbers in the display and explanation, so read and record the value from the actual unit rather than copying it.
A TRW diagnostic coverage list also lists Simos 4S for a Vento ADY example, but the same list has a Simos 2 entry for that model and code. Such tool entries describe a product's coverage and do not resolve the controller fitted to a particular car. Do not assume 4S, 4S2 and Simos 2 files or diagnostic procedures are interchangeable.
Cable throttle and idle control
In Volkswagen SSP 173, the throttle-control training example uses a cable for driver load input and an electric throttle positioner in the idle-control range. The programme identifies throttle potentiometer G69, positioner potentiometer G88, idle switch F60 and positioner motor V60. The ECU uses their feedback for idle and throttle closing; VW uses a Simos 4S display to illustrate self-diagnosis. This training description is not evidence that every 4S installation has identical components or diagnostic channels.
SSP 173 describes different fallback responses for different signal failures: for example, missing G69 can lead to a substitute value derived from engine speed and air mass, whereas missing G88 leads to the mechanical idle fallback. A similar high-idle symptom can therefore have different causes. Save fault codes and conditions and follow the vehicle-specific workshop test before attributing the complaint to a calibration.
Baseline and calibration work
- Record the exact ECU identification, engine and gearbox, fuel, modifications, complete fault scan and recent work. Check throttle cable operation, idle-switch and potentiometer signals, intake leaks, air-meter plausibility, ignition and fuel delivery as appropriate.
- For the throttle-control example, VW describes learned deviations and a basic setting after replacement of the throttle unit or ECU. It is a training example, not a universal procedure for all controllers or repairs. Follow the current workshop instructions and verify the reported result; do not mechanically adjust sealed sensors or indiscriminately clear learned values.
- Where the actual diagnostic tool supports them, compare engine speed, throttle and idle-switch state, air mass, lambda and ignition-related values under repeatable conditions. Confirm units and whether a value is measured or calculated. A scanner's ability to read a fault or measuring block does not establish calibration read or write support.
- Match definitions, file layout and programming method to the exact controller and software. Confirm original-data scope, checksum handling, stable supply and recovery for the selected tool. The sources here do not identify performance-map addresses, axes or numerical tuning changes.
Sources
- Volkswagen Passat workshop manual, Simos self-diagnosis identification, reproduced online. ADY/AGG 4S and AFT 4S2 examples, with an inconsistency in the reproduced AFT program-level display. Accessed 17 November 2026.
- Volkswagen SSP 173: throttle-control unit, German edition, January 1995, especially pages 5–7, 10–17 and 21–23. Training example and Simos 4S diagnostic display. Accessed 17 November 2026.
- TRW Easycheck vehicle application list 5.0.0. Historical product-specific coverage and conflicting Vento ADY entries. Accessed 17 November 2026.