Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
Simos
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Simos 8.6, also written 8.60, is documented on Audi 2.8-litre V6 FSI CHVA applications. The available sources below are an aftermarket conversion manual and tool and workshop records; they establish examples, not a complete factory fitment list or a verified map description.

Applications and identification

A 2013 Prins conversion manual identifies an Audi A6 2.8 CHVA automatic with the petrol ECU labelled Simos 8.60. Its title in the PDF's web address names a different engine code; the application stated inside the document is CHVA. The manual is for an aftermarket LPG conversion, so its converted fuel-system layout must not be assumed to describe an unmodified vehicle. [1]

Magicmotorsport's Flex 4.8.0.0 vehicle list also names 2010 Audi A7 2.8 FSI CHVA entries as Simos 8.6. A workshop example reports an A6 CHVA with identifier 4G0907552D and software 0004; those numbers identify that case, not all 8.6 ECUs. Record the actual hardware, full software and calibration identifiers, engine code and installed modifications. [2] [3]

Access and tool coverage

The historical Flex vehicle list gives OBD as the connection mode for its A7 CHVA entries. Separately, an Auto-Krak service page describes an unlock procedure for example Simos 8.6 units and says it can subsequently write by OBD or bench. An E-VAG case reports that its 4G0907552D 0004 required opening and unlocking. These are product- and case-specific claims: an OBD listing on its own does not establish whether a particular ECU is locked, needs preparation, or supports the read, write and recovery functions required. [2] [4] [3]

Check current tool documentation for the exact ECU and software, including any unlock prerequisites, checksum handling, file scope and recovery options. Identify whether a read is physical, calibration-only or a supplied virtual original before relying on it for recovery.

PCMflash's module 57 manual, page 49, states that its Simos 8.6 calibration reading and writing follows a bootloader-mode unlock; it separately lists EEPROM read, write and unlock functions. This is the provider's protocol-specific scope, not a requirement established for every tool or a promise of a complete recoverable image. Check the current documentation for the actual unit and operation.

Tuning and diagnostics

No verified Simos 8.6 map addresses, units or control strategy have been established by the sources listed here. Use software-matched definitions and verify them against the actual file; do not transfer maps or performance figures from Simos 8.1, 8.2, 8.4 or 8.5. For a baseline, review fault codes and compare available engine load, throttle, lambda, individual-cylinder knock correction and requested versus actual fuel pressure over repeatable runs. Diagnostic channel availability and interpretation depend on the exact software and tool.

Sources

  1. Prins, Direct LiquiMax-2.1 A6 application installation manual, 2013: document's CHVA and Simos 8.60 identification.
  2. Magicmotorsport, Flex 4.8.0.0 vehicle list: A7 CHVA entries and listed connection mode.
  3. E-VAG, A6 CHVA workshop case (Russian): specific identifier and stated access requirement.
  4. Auto-Krak, Simos 8.6 unlock service (Polish): provider's example ECU numbers and claimed workflow.