Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
Simos
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Simos 7PP is a Siemens/Continental petrol engine-management variant used on some Volkswagen Group 1.6-litre engines. Volkswagen documents it both on a petrol BSE engine and on the CHGA petrol/LPG BiFuel installation. The same ECU designation does not mean that every 7PP vehicle has an LPG system or shares the same calibration. Identify the controller and its software on the vehicle.

Documented examples

Volkswagen's Self-Study Programme 423 lists Simos 7PP on a BSE 1.6-litre, 75 kW petrol engine with two valves per cylinder. Its specified installation has a variable intake manifold and oxygen sensors before and after the catalyst. The programme is a description of that engine, not a fitment list for every BSE vehicle.

VW SSP 427 identifies Simos 7PP on the CHGA 1.6-litre BiFuel example. It lists 75 kW on petrol and 72 kW on LPG for that engine. These are factory figures for the documented configuration, not expected results from a remap. Although SSP 427 says CHGA is based on the CCSA FlexFuel engine, it explicitly says the described CHGA engine must not be run on E85. See Simos 7.7 for separately documented ethanol-capable examples.

How the documented BiFuel system works

On the SSP 427 installation, the Simos engine control unit J623 works with a separate gas-mode control unit J659. In LPG mode J659 receives the petrol injection signals and uses them to calculate the gas injection times; it controls the gas injectors. The gas-rail sensor G401 measures pressure and temperature, which help determine gas injector opening times. Fuel changes and gas faults therefore need to be considered across both control units, not attributed automatically to a petrol ECU map. See the English rendering of SSP 427.

The programme describes starting on petrol and switching to LPG after operating conditions are met. A low gas supply or certain gas-system faults can cause a return to petrol. Record the selected and actual fuel mode, warnings and fault codes before comparing behaviour between fuels. LPG equipment is pressurised; use the applicable current workshop procedures and competent service personnel for gas-system work.

For the documented CHGA changeover conditions, warning indications and dual-controller checks, see Simos 7PP CHGA BiFuel LPG switch-over and diagnosis.

Calibration and diagnosis

Begin with the exact ECU hardware, software and calibration identifiers, vehicle, engine, fuel equipment and gearbox. Check existing faults, fuel supply, ignition, air leaks and oxygen-sensor behaviour before calibration changes. For the BiFuel example, check both petrol and gas operation and the gas-control unit's diagnostics: a petrol-only test cannot establish that an LPG calibration or gas supply is correct.

Where the actual software and logger expose suitable channels, compare engine speed and load, lambda, fuel trims, ignition and knock correction, temperatures, throttle and fault status. For LPG also examine available gas pressure, temperature and switchover status in the gas controller. Verify each channel's meaning and units. A generic map name, file size or a Simos 7.1 definition alone does not prove a map belongs to a 7PP calibration.

Files and tools

Identify the exact controller and follow the selected tool provider's applicable instructions for reading, checksums, writing and recovery. This Simos 7.x service note distinguishes 7.1 and 7PP selections in one programming workflow; it is a supplier's guidance, not proof of the required connection or file layout for every ECU. Keep a recoverable original in the format supported by the actual tool. A change to the petrol ECU should not be assumed to recalibrate the separate gas controller.

Sources