Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
Simos
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Simos 8.2 is an engine-management variant documented on Audi naturally aspirated 3.2-litre V6 FSI applications. It should be identified from the actual vehicle and ECU software, rather than inferred from the broader Simos 8 family.

Documented application and identification

Audi's 2009 Q5 introduction identifies the 3.2 FSI engine with code CALB and 199 kW as using Simos 8.2. This is a documented application, not a complete fitment list. A CMDFlash release also lists an Audi S5 3.2 FSI ECU numbered 8T0907559 and a Q5 3.2 FSI numbered 8R0907559 under Simos 8.2. Record the full ECU hardware and software identifiers, engine code, vehicle and transmission before choosing a protocol or calibration. [1] [2]

Air and valve-lift control

On the documented Q5 CALB engine, Audi describes intake-side Audi valvelift (AVS): sliding cam pieces select smaller or larger intake cam lobes, changing intake-valve lift and duration. Electrically operated solenoids position the cam pieces under ECU control. This makes the physical lift changeover and its operation relevant when diagnosing a transient or drivability complaint; do not assume that every Simos 8.2 application has the same hardware or calibration. [1]

For comparison, the Simos 8.1 overview covers Audi's published descriptions for earlier V6 FSI examples. Its specific changeover strategy should not be assumed to apply unchanged to this ECU.

For CALB actuator implausible-signal codes and the vehicle-scoped Audi service bulletin, see V6 FSI valve-lift actuator diagnosis.

Calibration and logging

A commercial map pack for the specific Q5 calibration 8R0907559G 0004 advertises definitions for torque requests, requested engine load, base ignition, injection phase and rail pressure. These are the seller's labels, not independently verified function names, addresses, axes or evidence that definitions transfer to other software. Establish a definition against the exact read and validate its meaning before changing it. [3]

A practical baseline is to record fault codes and fuel quality, then compare available requested and actual engine load, throttle, cam position and rail pressure alongside engine speed, lambda and individual-cylinder knock corrections. Check valve-lift operation when available and compare repeat runs at similar temperatures. Channel availability and interpretation depend on the ECU software and diagnostic equipment; these are suggested observations, not claims that every channel exists on every variant.

Reading and writing

The 2013 CMDFlash v3.2.0.116 release note lists CAN read, write, checksum and recovery for the stated S5 and Q5 identifiers, in the context of corrected reading issues. This is historical product-specific coverage, not a guarantee for another software version, tool or an unmodified ECU. Confirm the tool's current application list and recovery procedure for the exact ECU. [2]

Distinguish a physical read, a calibration-only read and a supplied or virtual original; establish exactly what memory each contains and what the selected recovery method requires. The seller of the example above explicitly says its original file is not a full backup and does not include EEPROM. Do not treat a matching part number or purchased original alone as proof of recovery compatibility. [3]

Sources

  1. Audi of America, 2009 Audi Q5 Vehicle Introduction (SSP 994803), third-party text mirror: CALB engine management and AVS description.
  2. CMDFlash v3.2.0.116 release note: historical tool coverage and listed identifiers.
  3. Auto-Remap, 8R0907559G 0004 Simos 8.2 map-pack listing: seller's file-specific labels and file-scope statement.