Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Tuning
Parent
Simos 12
Applies to
Simos 12
Tool groups
None
Manufacturers
None

On the third-generation 1.8 TSI described in SEAT Self-Study Programme 158, Continental Simos 12 controls an electric turbocharger wastegate and a separate compressor recirculation valve. Understanding their different roles helps when a tuned car misses its pressure request or responds poorly after a lift. These descriptions apply to the engine in the programme; identify the actual ECU, turbo and software on the vehicle being tested.

Request, actuator and feedback

SEAT describes the engine control unit calculating required charge pressure for the requested torque from accelerator and engine-speed information, with coolant temperature, intake-manifold information and ambient pressure among the corrective inputs. The ECU drives electric actuator V465 to move the wastegate and uses charge-pressure sensor G31 and actuator-position sender G581 to check the result. A pressure target is therefore not itself proof of a working actuator or achieved torque.

V465 contains an electric motor, gearing and rod. SEAT describes a pulse-width-modulated motor drive whose polarity can reverse, and G581 as a Hall-type position sensor generating a position-dependent signal. The programme says that a missing G581 signal is accompanied by a perceived torque loss; actuator failure removes normal boost regulation and also results in lost torque. The sensor's stated 0–5 V signal span is a description of the signal, not a universal closed-position adjustment specification. Use the current vehicle-specific workshop procedure for any electrical measurement, adaptation or replacement.

Distinguish wastegate from compressor bypass

The same SEAT programme describes N249 as the turbocharger air-recirculation valve: its bypass connects the compressor outlet and inlet. ECU activation opens this bypass; the programme associates a failed valve with a loss of power when accelerating after deceleration. That transient symptom is a reason to check the system, not proof of an N249 fault. V465 and N249 have different jobs; do not interpret a recirculation-valve command as wastegate position.

A practical logging sequence

  1. Record ECU identification, calibration, fuel, modifications, diagnostic trouble codes and freeze-frame data. Resolve relevant mechanical, electrical or cooling faults before attributing reduced performance to a calibration.
  2. On repeatable, lawful tests at similar temperatures and engine speeds, compare accelerator input, requested and actual torque or load where available, throttle, charge-pressure request and actual pressure. Confirm units and whether pressures are absolute or gauge values; identify sensor locations before comparing them.
  3. Where the logger supports them, align wastegate command and measured position with pressure error, engine speed, intake and coolant temperatures, and intervention flags. A reduced request suggests a different line of investigation from an unchanged request that is not achieved. Neither pattern alone identifies the cause.
  4. If the complaint follows lift and reapplication, capture the deceleration-to-acceleration transition and available N249 command alongside throttle and pressure. Inspect the intake and charge-air system and use the specified output and electrical tests to investigate the valve and actuator.

Channel names, sample rate and availability depend on the diagnostic tool and software. Command, position, measured pressure and calculated load are different signals. Do not infer movement or adaptation success from a single duty-cycle value, and do not use this description to set a rod length or copy another ECU's map.

A separate VW service example

A June 2015 Volkswagen on-car analysis list requested dealer contact for selected 2014–15 models with specified 1.8T engine codes and both P2563 and P00AF. That historical list identifies a complaint pattern for those vehicles, not a diagnosis, repair instruction or confirmation that every listed vehicle has Simos 12. Match vehicle, ECU, fault conditions and current service information before applying any bulletin.

Sources