Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
Simos
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Simos 16 is a Continental petrol engine-management family used on some supercharged 3.0 V6 TFSI applications. Audi's published technical data identifies Simos 16 on the 245 kW Q7 3.0 TFSI quattro described there. Exact ECU, hardware and software identifiers are needed to establish the variant and calibration in a particular vehicle.

Applications and identification

The Audi Q7 technical specification describes a mechanically supercharged 3.0 V6 with combined direct and manifold injection, two intercoolers and Simos 16 engine management. It does not identify a Simos 16 suffix on the cited sheet. It also describes cylinder-selective adaptive knock control and lambda control. The entry is an example, not a complete fitment list.

APR's 2017 product announcement lists Simos 16 on selected supercharged 3.0 TFSI applications; it describes its own products and hardware combinations, not all vehicle and software combinations. Some earlier 3.0 TFSI installations use Simos 8.4 or 8.5. Record the ECU part number, hardware, software and calibration before selecting a file or procedure.

Related engine design: EA837 evo

Audi Self-Study Programme 624 describes the fourth-generation EA837 evo using engine code CREA as its example. It calls that engine's management “Simos” without stating the ECU generation. The following is engine-system context; the programme alone does not prove that every CREA or EA837 evo has a Simos 16.

The documented engine combines FSI direct injection and MPI manifold injection, and uses a belt-driven Roots supercharger with an electromagnetic clutch. At low and medium engine speeds and low load, the clutch can release the drive; it engages when required. A control flap and throttle participate in managing air and the transition. Audi describes a supercharger speed sensor G688 used in clutch engagement control and monitoring. A calculated stress factor, rather than a dedicated clutch temperature sensor, provides a basis for protecting the clutch against repeated switching. These descriptions are specific to SSP 624's system.

On the documented EA837 evo, direct and port injection can be used in different combinations as operating conditions change. The presence of both systems and their control should be checked on the actual engine and calibration. The earlier Simos 8 overview describes a different 3.0 TFSI example; do not transfer its component or map assumptions automatically.

For the documented magnetic-clutch and G688 control system, log review and a scoped Q7 bulletin example, see EA837 evo supercharger clutch diagnosis.

Tuning and logging considerations

Identify the fitted supercharger, pulley sizes, cooling and fuel system before selecting a calibration. APR's product announcement distinguishes its stock-hardware calibration from single- and dual-pulley packages; those requirements apply to its own offerings, not to every product or vehicle. Do not assume a quoted stage or power figure establishes the correct hardware or fuel for another calibration.

After establishing a fault-free baseline, log supported channels for requested and actual charge pressure, throttle and bypass behaviour, intake and coolant temperatures, lambda target and actual, fuel pressures, ignition and knock correction. Where available and correctly defined, examine supercharger speed, clutch command or status, and injection-mode information. The availability, units and whether values are measured or modelled depend on software and diagnostic equipment. An unexpected transition or lack of boost needs diagnosis of the control, drive and mechanical system; it is not proof that a torque limit should be raised.

Match definitions and checksums to the exact software. The sources here do not establish universal map addresses, safe boost or ignition targets, or an interchangeable programming method. Confirm the chosen tool's read/write support, stable supply and a verified recovery path before programming.

Sources