ABS and traction systems directory · Mando ABS units
MGH-20 is identified as a series-production Mando ABS in an SAE technical paper about the hydraulic braking system. The paper's family designation does not establish a particular vehicle application or part-number interchange.
Documented applications
Mando identifies MGH-20 as a series-production ABS family. One T11 application is described below; exact part-number interchange still requires vehicle-specific verification.
Identification and service
Record the full supplier and vehicle-manufacturer part numbers, vehicle VIN and fitted equipment, software version and coding where available. Use the vehicle-specific service information to confirm diagnostic capabilities, component compatibility, bleeding and any setup or calibration. A family designation alone is not a replacement-part specification.
Vehicle-specific example
The Chery Tiggo T11 service manual describes an MGH-20 supplied by Mando on the T11, with four-channel control of the individual wheel brakes. The cited manual does not establish that every Tiggo T11, market or year has this unit; identify the fitted actuator and use the correct vehicle documentation.
The manual includes a system wiring schematic in its chassis section, printed page 42, as well as diagnosis and HECU replacement and bleeding guidance. The schematic should be checked against the exact vehicle and controller before using its pin numbers. Source: T11 service manual, chassis system, ABS section (third-party hosted copy).