Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
ABS / DSC
Parent
Hondata Traction Control module
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
Hondata

This reference reproduces the wire-side connector layouts and harness colours in the Hondata traction control connector guide. The maker shows the connector from the wire side in two rows of ten positions, but does not label physical cavity numbers in this diagram: the rows below preserve its left-to-right order and should not be treated as manufacturer pin numbering. Confirm connector keying and orientation against the original guide.

Wire-side layout, left to right

RowFunctions in manufacturer diagram order
TopGND+12 VOut1Out2Out3Out4LF+RF+LR+RR+
BottomGND+12 VSerial OutCAN LCAN HECULF−RF−LR−RR−

LF/RF/LR/RR mean left-front/right-front/left-rear/right-rear wheel-speed inputs. The ECU connection is an analogue over-slip signal to a compatible engine ECU. Out1–Out4 are 3.3 V pulse outputs with 5 mA maximum load; the maker says not to connect them to power or ground. The serial output is 0 V idle, 3.3 V active. The labelled GND and +12 V positions appear twice in the source diagram; wire colours are given there for one of each, so do not assume the other has the same harness colour.

Documented harness-colour revisions

FunctionMarch–October 2012 diagramOctober 2012 onward diagram
GNDBlackBlack
+12 VRedRed
ECUOrangeOrange
LF+BlueBlue
LF−Light blueYellow
RF+GreenGreen
RF−Light greenWhite
LR+BrownBrown
LR−TanGrey
RR+VioletPurple
RR−PinkPink

Hondata labels both date ranges with October 2012 as a boundary, so identify the actual harness rather than relying on the date alone. Switching ground and ECU output can damage the module. The connector guide specifies ECU ground close to the ECU, not chassis or ECU case; consult the separate Hondata quickstart for its stated ECU-master-ground alternative and current installation instructions.

Supplier-documented application examples

Hondata's sensor-wiring examples include 1996–2000 Civic, 2002–2006 Acura RSX, 2000–2005 and 2006–2009 S2000, and 2006–2011 Civic Si. These identify integration examples, not a guarantee for every market or ABS variant. Hondata identifies the 2006–2011 Civic Si example as active-sensor ABS and warns that incorrect wiring can disable ABS. Its guide notes similar colours occur more than once and requires the exact vehicle wiring information. See the manufacturer connector and application guide and sensor-type-specific installation notes.