Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Engine ECU
Parent
PnPduino standalone ECUs
Applies to
PnPduino standalone ECUs
Tool groups
None
Manufacturers
None

PnPduino Mitsubishi EVO3 is a PnPduino programmable engine-management ECU. Manufacturer product information.

PnPduino Mitsubishi EVO3
PnPduino Mitsubishi EVO3. PnPduino manufacturer product photograph, reproduced with permission.

Application and identification

Manufacturer identifies the application by a three-plug, 64-position Mitsubishi harness for 4G63T and 4G92/4G93 applications. The product is named EVO3, but the engine and three-plug connection must be checked against the specific vehicle rather than assuming all EVO variants are compatible.

System and wiring

The original trigger can be used; the supplier encourages the supplied 24+1 trigger disc. The original MAF is not used: the ECU’s onboard MAP sensor must be connected. Both high- and low-impedance injectors are listed, and the original resistor box may be removed according to the product instructions. OEM idle servo support and an alternative two-wire idle valve are described.

Connector identification

ConnectorManufacturer descriptionScope
Vehicle ECU connectors3 plugs, 64 positions totalConfirm exact mating loom and pinout; a complete cavity assignment is not supplied in the product listing.

A complete pin-by-pin ECU connector table has not been verified from the cited product information. Obtain the diagram for the exact model and revision from PnPduino documentation; the vehicle ECU pinout and other PnPduino models must not be assumed interchangeable.

Software and calibration

Uses Speeduino firmware and TunerStudio. A separate wideband controller and a final tune are required.

See the PnPduino manufacturer index.

Model-specific wiring document

The supplier publishes its own model-specific three-connector pinout with OEM and controller functions, wiring notes and colour-coded changed and unused signals. Check the exact engine and loom before using it. Open the PnPduino pinout document. The page’s connector-identification table is not a complete cavity-by-cavity schedule.