Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
ABS / DSC
Parent
Bluegrass MK60E5 E1 to Haltech CAN gateway
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
Bluegrass Race Electronics

The following positions are for the eight-way Deutsch connector on the BRE MK60E5-to-Haltech CAN gateway in the manufacturer’s installation instructions v1.2, revised 19 September 2024. They are gateway connector numbers, not ABS control-unit or generic Haltech ECU connector numbers. Confirm connector orientation and version against the source. BRE instructions, page 1.

Gateway positionFunction
1Ground
2CAN 1 low — Haltech side
3CAN 2 low — MK60E5 PT-CAN side
4Not used
5Not used
6CAN 2 high — MK60E5 PT-CAN side
7CAN 1 high — Haltech side
86–30 V DC supply

BRE specifies ignition-switched supply and shows the gateway CAN2 connected to MK60E5 PT-CAN high at ABS pin 30 and low at ABS pin 15 for this documented configuration. Match the actual module and harness; do not apply this to the original non-E MK60. The product page also lists MK60E1 compatibility, with its pressure-signal limitation; confirm its exact wiring with the supplier.