Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Engine ECU
Parent
PnPduino standalone ECUs
Applies to
PnPduino standalone ECUs
Tool groups
None
Manufacturers
None

PnPduino Universal is a PnPduino programmable engine-management ECU. Manufacturer product information.

PnPduino Universal
PnPduino Universal. PnPduino manufacturer product photograph, reproduced with permission.

Application and identification

A configurable wire-in ECU that the manufacturer says can operate as a standalone or piggyback and supports engines up to eight cylinders. The manufacturer specifies manual transmission and cable-throttle use.

System and wiring

The input header is a 34-position AMP Superseal 1.0 three-slot connector; the output header is a separate 26-position three-slot connector. Optional components include an internal 4-bar MAP sensor, Bluetooth, VR conditioner, stepper driver and wideband. The ASA/ABS case is not waterproof and the manufacturer says to install it inside the car.

Connector identification

ConnectorManufacturer descriptionScope
Input header34 positions, AMP Superseal 1.0, three-slotManufacturer product listing
Output header26 positions, AMP Superseal 1.0, three-slotManufacturer product listing

A complete pin-by-pin ECU connector table has not been verified from the cited product information. Obtain the diagram for the exact model and revision from PnPduino documentation; the vehicle ECU pinout and other PnPduino models must not be assumed interchangeable.

Software and calibration

The product lists TunerStudio and official Speeduino firmware. Verify outputs, sensors and firmware for the actual build and obtain the model-specific pinout before wiring.

See the PnPduino manufacturer index.