Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
Link standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Link G4+ Xtreme is a programmable G4+ wire-in engine-management ECU. A/B loom unit with electronic-throttle outputs. The guide says PCB v1.3b and earlier have DI 9/10 only; PCB v1.4 and later can use those pins for DI 9/10 or CAN 2. Link G4+ Xtreme quick-start guide.

Model identification and I/O

ItemDocumented details
ECU familyG4+
Outputs8 injection and 8 ignition drives
ProgrammingPCLink version matched to ECU generation and firmware
Connector and loomSee the exact-model guide, including connector keys, wire-side orientation and optional functions

The manufacturer guidance and wiring identify the hardware; driver counts do not establish injector electrical compatibility or imply all multiplexed pins can be used at the same time.

Model-specific pinout and installation

The G4+ Xtreme quick-start guide provides the connector diagrams and installer I/O table. Refer to that version for numbered cavities, wire colours, supply, grounds, driver and sensor connection notes. Loom wire-side and ECU header views are identified on the diagram; do not transfer a pin number from another generation.

Software and further sources

Download software, firmware and full installation help from Link's download centre; identify the ECU generation and installed firmware before choosing a PCLink package. The legacy software list separates G5, G4X and G4+ compatibility. See also Link standalone ECUs.

Link G4+ xtreme ECU
G4+ Xtreme black-series package as shown in Link’s catalogue; other revisions differ. Image: Link Engine Management G4+ catalogue, reproduced with permission.