Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
Link standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Link G4+ Thunder is a programmable G4+ wire-in engine-management ECU. Higher-I/O G4+ unit; the guide identifies up to 16 analogue voltage inputs and electronic-throttle functions. Individual inputs and outputs may share duties. Link G4+ Thunder quick-start guide.

Model identification and I/O

ItemDocumented details
ECU familyG4+
Outputs8 injection and 8 ignition drives
ProgrammingPCLink version matched to ECU generation and firmware
Connector and loomSee the exact-model guide, including connector keys, wire-side orientation and optional functions

The manufacturer guidance and wiring identify the hardware; driver counts do not establish injector electrical compatibility or imply all multiplexed pins can be used at the same time.

Model-specific pinout and installation

The G4+ Thunder quick-start guide provides the connector diagrams and installer I/O table. Refer to that version for numbered cavities, wire colours, supply, grounds, driver and sensor connection notes. Loom wire-side and ECU header views are identified on the diagram; do not transfer a pin number from another generation.

Software and further sources

Download software, firmware and full installation help from Link's download centre; identify the ECU generation and installed firmware before choosing a PCLink package. The legacy software list separates G5, G4X and G4+ compatibility. See also Link standalone ECUs.

Link G4+ thunder ECU
G4+ Thunder as shown in Link’s catalogue. Image: Link Engine Management G4+ catalogue, reproduced with permission.