These selected 38-position ABS M4 ECU assignments are transcribed from Bosch Motorsport’s standard ABS M4 wiring diagram F.02U.S00.043-09 in the linked manual, printed page 50. This is a diagram-specific reference, not a universal claim for all M4 vehicle-specific harnesses or road ABS units. Other positions are not specified here. WS and WP and their black/white wire descriptions are retained as printed; do not infer sensor polarity from the names alone. Check the original drawing for connector orientation, wiring options and electrical protection.
| ECU pin | Function in the cited diagram |
|---|---|
| 1 | VBat motor relay; S1 fuse 40 A |
| 2 | Switch 1 |
| 3 | A_GND for pressure sensor |
| 4 | ABS warning lamp |
| 5 | VB switch |
| 6 | WS front right, black |
| 13 | Motor ground |
| 14 | CAN low |
| 15 | V_Stab +5 V |
| 17 | Diagnostic K-line |
| 18 | WP front right, white |
| 19 | WP rear right, white |
| 20 | WS rear left, black |
| 21 | WP front left, white |
| 22 | WS front left, black |
| 25 | VBat valve relay; S2 fuse 25 A |
| 26 | CAN high |
| 27 | Switch 2 |
| 30 | Brake-light switch input (+BLS) |
| 31 | WS rear right, black |
| 32 | KL15 switched supply; S3 fuse 10 A |
| 33 | WP rear left, white |
| 35 | Brake-pressure sensor signal |
| 38 | Valve ground |
Source: Bosch Motorsport ABS M4 manual, section 16 and page 50. The wheel-speed interface and sensor adapters vary with the kit. The similar M5 connector is not a compatible harness: consult the respective Bosch instructions before wiring.