Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
ABS / DSC
Parent
Unavailable reference hub
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
Happy Cactus Garage

These are the two 12-position connectors of the Happy Cactus Garage MK60 ABS VR/Hall Converter interface, not a generic ABS ECU pinout. The vendor links the following wiring and setup documentation from its product page. The grey A-keyed connector interfaces to the ABS module; the black B-keyed connector interfaces to the chassis. Verify keying, cavity numbers, sensor type and actual harness against the manufacturer documentation.

Grey ABS-module connector, DTM06-12SA / ATM06-12SA

PinFunction
1Powertrain CAN low
2Brake switch signal to ABS controller
3Rear right wheel sensor output −
4Rear left wheel sensor output −
5Front right wheel sensor output −
6Front left wheel sensor output −
7Front left wheel sensor output +
8Front right wheel sensor output +
9Rear left wheel sensor output +
10Rear right wheel sensor output +
11Switched ignition power
12Powertrain CAN high

Pin 2 is the conditioned brake signal to the ABS brake-switch input only. The documentation shows different ABS ECU pin assignments for MK60 and MK60E1/E5; consult its model-specific cross-reference rather than assuming the converter pin number is the ECU pin number.

Black chassis connector, DTM06-12SB / ATM06-12SB

PinFunction
1Left front VR sensor −
2Right front VR sensor −
3Left rear VR sensor −
4Right rear VR sensor −
512 V brake-light signal input
6Speedometer output, 5 V PWM
7ABS/DSC fault lamp output; MK60E1/E5 only
8VR input wiring shield
9Right rear VR sensor +
10Left rear VR sensor +
11Right front VR sensor +
12Left front VR sensor +

The maker says the VR +/− labels follow wiring diagram convention and sensor polarity does not matter. Pin 7 fault output is for MK60E1/E5. Supported Hall configurations and tone-ring requirements must be checked in the current manufacturer setup guide. These tables do not establish a generic pinout for other conversion interfaces or ECU variants.