Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
MBE Systems standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

The MBE 912 is an early engine-management controller. A 1993 period article hosted by SBD describes a 912 controlling injection and distributorless ignition in one engine installation. This example does not establish the capabilities of every 912 hardware variant.

Identification and software

Record the full label, hardware and firmware revision, vehicle installation and existing calibration before changing the unit. Ask MBE or SBD for the correct documentation and supported interface; the mapping software and cable used on newer CAN units should not be assumed compatible. MBE software and connection guidance.

Throttle potentiometer connections — partial

SBD’s throttle-pot wiring guide explicitly lists these connections for its 956/912 application. It is a partial connector schedule: it does not establish all 912 revisions or the complete main connector. Confirm the original harness and hardware before connecting.

ECU pinThrottle sensor connection
1Electronics ground / sensor return
55 V throttle reference
15Throttle signal

See the MBE Systems model index for other separately documented controllers.

912-C main ECU connector

The following 15 positions are from the SBD MBE912 pinout sheet, headed 912-C and dated January 2014. Confirm the exact ECU suffix and installation before applying the table to another 912 version. The sheet’s second page includes Ford and GM crank sensor wiring, including the GM screen on ECU pin 4; use that diagram for the sensor and harness being installed.

ECU pinSignal
1Electronics ground
2ECU supply +12 V
3Ignition drive 1
4Power ground 2 (braid)
5Throttle reference (5 V out)
6Speed signal
7Air temperature signal
8Coolant temperature signal
9Power ground 1 (braid)
10Ignition drive 2
11Injector drive
12Speed return
13Tacho signal
14Fuel pump relay or gearshift light
15Throttle signal

912/956 wiring harness interface

SBD’s separate 912–956 series wiring instructions identify a four-way Sure Seal harness interface; these are interface positions, not the numbered main ECU connector above. Pins 1 and 2 receive battery positive through a relay as shown in the SBD diagram. Identify the interface and harness before making connections.

Interface pinHarness colourFunction in SBD harness
1PurpleBattery positive via relay
2WhiteBattery positive via relay
3GreyGearshift light earth trigger
4GreenRev counter