Audi's 0GC is a seven-speed transverse DQ381 transmission; its 0DL is a seven-speed DQ500 application. Audi's A3 powertrain training identifies 0GC as DQ381, and its Q3 training identifies 0DL as DQ500-7A. They are different gearbox families even though some diagnostic bulletins discuss both. Identify the vehicle, transmission, mechatronic assembly, TCM hardware and software; a component part number beginning 0GC does not by itself prove that the complete gearbox is a DQ381.
Clutch position-sensor electrical faults
Audi's historical North American TSB 35 20 37 / 2058504/1 covers listed 2017–2020 A3, A3 Cabriolet, S3, RS3 and TT RS, and listed 2019–2020 TTS and TT Roadster vehicles with 0GC/0DL. It describes shudder, a gearbox warning or a restricted odd- or even-gear mode together with P173500 and symptom code 10666 for clutch-position sensor 1 and/or P173600 and symptom code 10668 for sensor 2. Audi described a mechatronic hardware issue for the documented combination. The code and symptom suffix, actual model and gearbox all matter; the same warning or a base code alone does not establish this fault.
Audi's separate TSB 35 23 44 / 2070217/1 covers specified later model ranges and lists additional clutch, selector, input-speed and control-module fault combinations for 0GC/0DL. Its historical service path first requires the TCM software part number and software version to match its table, then differentiates the mechatronic index and control-unit parts. An 0DL gearbox can have a mechatronic unit with an 0GC index in that bulletin. Neither the code family nor the prefix alone is a replacement-parts verdict. Audi's 2020 and 2023 service procedures are distinct historical instructions; consult the latest vehicle-specific guided test and repair information before choosing a path.
Clutch-wear pattern: 0GC example
For listed 2017–2020 A3 and A3 Cabriolet, 2018–2020 S3 and 2019–2020 TT-family 0GC vehicles, Audi TSB 30 20 29 / 2060560/1 describes possible take-up slip, a gearbox warning or shudder on shifts into odd-numbered gears. Its specific workshop findings combine a very high calculated maximum K1 temperature, dark burnt-smelling transmission fluid and relevant faults; it first directs a check of another applicable bulletin. Audi identifies K1 wear in that documented case. An odd-gear symptom, dark fluid or a calculated temperature alone is not proof of a worn clutch. Check all specified conditions and current guided diagnosis; the stored calculated value is not an independent direct temperature measurement.
Diagnostic and service boundaries
- Record the VIN, gearbox designation, TCM software number and version, previous programming or component work, symptoms, gear, temperature and complete DTCs with their manufacturer symptom codes before clearing or adapting.
- Use the vehicle-specific guided test to compare requested and actual gear, clutch and shaft speeds, pressure and temperature data where supported, supply and electrical communication. An odd/even pattern helps organise evidence but can reflect different sensor, hydraulic, mechanical or control causes.
- Follow current manufacturer procedures for fluid identification and level, mechatronic repairs, programming and basic settings. Identical fault-code labels do not establish identical fluid, hardware or repair strategy for 0GC and 0DL. A reset or adaptation cannot fix a hardware defect or a worn clutch.
See DQ500 identification and shift selection, DQ250 diagnosis and the electronic gearbox index.