Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
Link standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Link G1 LinkPlus V10 is a documented G1 Link engine-management designation. Link lists LinkPlus V10 as a G1 ECU for legacy PCLink V2.5. A LinkPlus designation alone is insufficient to select software or wiring. Identification source.

Identification and software

Record the complete model and revision label, board identifiers, installed firmware, connector configuration and any adapter loom. Similar Link model names occur in later generations. Use the manufacturer's legacy PCLink compatibility table and seek Link support if the appropriate package is unclear.

Model-specific wiring

The identified manufacturer documentation or legacy manual archive is the starting point for this model. An individual pin-by-pin allocation was not verified in this reference; obtain the exact matching manual and connector orientation before wiring.

See Link standalone ECUs for related models and generation distinctions.

Generation and firing sequence

Link staff distinguish G1 and G2 LinkPlus wiring: G1 wiring uses firing sequence, while G2 channel numbering follows injector numbering. Verify the exact V10 manual, fuel mode, trigger configuration and firing sequence; do not treat a G2 schedule as a V10 cavity chart.