Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
Link standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Link G1 LinkPlus V14 is a documented G1 Link engine-management designation. Link lists LinkPlus V14 as a G1 ECU for legacy PCLink V2.5. G1 help is provided separately for later Windows releases. Identification source.

Identification and software

Record the complete model and revision label, board identifiers, installed firmware, connector configuration and any adapter loom. Similar Link model names occur in later generations. Use the manufacturer's legacy PCLink compatibility table and seek Link support if the appropriate package is unclear.

Model-specific wiring

The identified manufacturer documentation or legacy manual archive is the starting point for this model. An individual pin-by-pin allocation was not verified in this reference; obtain the exact matching manual and connector orientation before wiring.

See Link standalone ECUs for related models and generation distinctions.

Documented V14 breakout loom colours

Link's LinkPlus V14 manual, pages 8–9, identifies these functions and wire colours in the manufacturer breakout loom. This is a colour/function reference, not a numbered connector-cavity map: obtain the matching manual and inspect its wire-side header diagram before identifying positions. Wiring can differ with individual loom and internal configuration. Link staff identified the V14 manual as the relevant reference in their support forum.

The manual's extracted diagram labels Trigger 1 yellow while its separate wire list says white; verify the original connector and build with Link. The manual also varies between yellow/red and yellow/blue in the Aux 2 description; the table follows the colour list, and this connection must be verified before use. Drives and injector assignments depend on firing sequence, trigger and selected injection mode. This table is not verified for V10 or later LinkPlus generations.

Manufacturer loom functionWire colour / source note
Injector 1Brown/Black
Injector 2Brown
Injector 3Brown/Red
Injector 4Brown/Orange
Injector 5Brown/Yellow
Injector 6Brown/Green
Injector 7Brown/Blue
Injector 8Brown/Purple
Ignition 1Blue
Ignition 2Blue/Black
Ignition 3Blue/White
Ignition 4Blue/Brown
Ignition 5Blue/Red
Ignition 6Blue/Orange
Ignition 7Blue/Yellow
Ignition 8Blue/Green
Ignition invertedPink
Power drive AOrange
Power drive BOrange/Black
Idle speed control 1Orange/Green
Idle speed control 2Orange/Blue
WastegateOrange/Yellow
Fuel pumpPurple
ShiftWhite/Black
PurgeWhite/Brown
FanWhite/Red
SprayWhite/Yellow
TachometerWhite/Green
A/C onWhite/Blue
Stepper AGrey
Stepper BGrey/Black
Stepper CGrey/Blue
Stepper DGrey/White
Engine temperatureYellow
Air temperatureYellow/Black
Throttle positionYellow/Orange
A/C requestYellow/Red
MAPYellow/Brown
OxygenWhite
Aux input 1Yellow/Green
Aux input 2Yellow/Blue
Power inRed
+5V outputRed/Blue
+12V sensor outputRed or green in trigger cables
Signal groundBlack
Power groundBlack
Knock 1Red, screened cable
Knock 2Red, screened cable
Trigger 1Conflicting source labels: yellow or white, screened cable
Trigger 2Blue, screened cable

The manual specifies group-fire operation using injector drivers 7 and 8, and describes ballast selection by injector resistance and delivery mode. Follow the original guide for the actual installation.