Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
ABS / DSC
Parent
RaceTCS traction control systems
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
RaceTCS

ABS and traction systems · RaceTCS · Motorsport overview

RaceTCS V2 is a standalone traction controller that compares driven and reference wheel speeds and reduces engine output by cutting complete fuel-injector pulses. It does not modulate hydraulic brakes and is not ABS. RaceTCS V2 user manual, pp. 3–4.

Functions and applicability

The cited V2 manual lists a target-slip limiter and RPM limits, including configured launch and flat-shift functions. It describes sequential or batch/bank petrol injection subject to its stated electrical limits, and explicitly says fuel cut is not supported for direct-injection engines. It also specifies injector impedance and excludes PWM-controlled injectors; use the exact manual and supplier to establish compatibility. V2 manual, requirements.

Wheel-speed sensing and engine-output wiring must be checked for the particular vehicle. The manufacturer identifies V2 as motorsport equipment and warns that incorrect installation can damage components; verify class rules and commissioning procedures.

Documented vehicle examples

The manufacturer provides example installation schematics for Nissan 350Z and 300ZX, Opel Speedster/VX220 turbo, BMW E36 and E46, Mazda RX-8 and MX-5 NC (pre-facelift and 2012 onward), and fifth-generation Ford Mustang GT. These are aftermarket installation guides, not factory fitments; check the engine, ECU, connector and diagram for the specific car. Manufacturer manual: car-specific schematics.

Connector pinout

RaceTCS V2 connector pinout — model-specific manufacturer wiring reference.