Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Gearboxes
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

The Ferrari 612 Scaglietti was offered with an electrohydraulically operated F1 gearbox and a separate mechanical-shift version. This guide concerns the F1 version described in Ferrari's reproduced 612 owner's handbook and the distinct 2005–2007 US recall described below. Identify the exact car, market, model year, transmission, controller and software before applying a procedure. F1 transmission details and calibrations must not be assumed to be the same as those of a 355, 360 or F430.

Known clutch sensor recall: 2005–2007 US cars

Ferrari North America's recall campaign 47 / NHTSA 08V214 concerned specified 2005–2007 model-year 612 Scaglietti vehicles with F1 transmissions. The manufacturer identified a clutch sensor that did not meet its material specification and could malfunction under normal vehicle heat. Ferrari reported that the resulting failure could inhibit proper clutch function and make shifts very difficult, with the system illuminating a warning. Its recall remedy replaced the sensor as well as a cable holder and magnet.

The campaign includes a list of affected VINs and differentiates hardware by assembly group. Check the individual vehicle's current recall and repair history with Ferrari or the relevant regulator; a similar symptom or a car within a broad model-year range does not prove the recall condition is present. Ferrari's owner notification told recipients of the affected US vehicles to contact a dealer immediately and avoid driving until the recall repair was completed. Different markets and later repair history require their own checks. Ferrari North America recall instructions and owner notice.

What the handbook's indications mean

  • Pump on door opening: the cited handbook says the F1 pump may run briefly when the driver's door is opened to prepare the system. That event alone is not proof of a defective pump.
  • Warning and gear display: the handbook associates a continuously illuminated F1 failure warning and acoustic signal with a system fault. A flashing gear display, including N, means the selected gear has not been correctly engaged or disengaged in its described scenario; a dash with the failure lamp also indicates a fault. The symptom does not identify the failed sensor, actuator or circuit.
  • Pressure and oil-level indications: the same handbook describes a flashing F1 failure warning as a low-pressure indication and a separate low F1 system oil-level warning requiring inspection. A brief warning during start-up is described separately. Neither indication by itself establishes whether there is a leak, pump fault or faulty feedback.
  • Selection interlocks: the handbook says gear engagement is inhibited if the driver's door, engine compartment or luggage compartment is open or not properly closed. Check actual and controller-reported interlock states as directed; do not defeat an interlock to force a shift.

These are interpretations from the cited 612 handbook, particularly its warning and starting/driving sections. Display meanings and conditions can vary with equipment and handbook edition; use the handbook for the actual car.

Workshop investigation

  1. Capture the complaint, requested and displayed gear, warning, ambient and operating temperature, recent clutch or hydraulic work, VIN, campaign status and complete fault records before clearing them.
  2. Use the current Ferrari diagnostic plan to compare the relevant clutch request and position feedback, gear and interlock states, power supply and hydraulic pressure feedback when available. A sensor-related code or hard shift does not on its own identify a defective sensor, worn clutch or low physical pressure.
  3. For pressure or oil-level concerns, inspect the specified system and any leaks using the correct procedures. A pump sound is not a pressure measurement, and the hydraulic actuator circuit is not interchangeable with the mechanical gearbox lubrication circuit.
  4. The hydraulic system can retain pressure and the actuators can move automatically. Secure the vehicle and follow the current Ferrari isolation, depressurisation, repair and model-specific learning instructions. Complete only the service functions required for the actual work and verify the original complaint.

See also Ferrari 360 F1, F430 F1 SD3 diagnosis and the F1-style gearbox overview.