
DTAFast's S-series feature matrix states that an ignition-only S40 version was available. A distributor lists it as S40i; identify the exact case label and firmware rather than assuming that every S40 has functioning fuel outputs. Manufacturer document.
Identification and operating context
This is included for identification as an ignition controller. Record the exact product label, hardware, firmware and loom; do not assume compatibility with a similarly named fuel-and-ignition ECU. See DTAFast family overview.
Wiring
The manufacturer S40 Pro diagram is a family reference, not proof that every function is populated in an ignition-only ECU. Obtain the exact build information from DTAFast before wiring. DTAFast wiring reference. Establish fused supplies, grounds, sensor connections and coil-driver limits for the specific unit.
Documented gearshift controller connections (partial)
TTT Racing explicitly identifies the DTA S40 and S40 Ignition in its TTT802 interface guide, revision 8, pages 2–4. This is an application-specific connection list, not a complete ECU pinout. The descriptions below identify the TTT802 wire function rather than asserting the full electrical specification of each ECU pin; configure and verify the ECU and hardware before connection.
| DTA ECU pin | TTT802 connection described by the guide |
|---|---|
| 11 | Red — cut open-collector |
| 28 | Blue — cut ground |
| 26 | White — ignition pulse |
| 13 or 14 | Black — ignition pulse ground |