Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
ABS / DSC
Parent
Delphi DBC 7 ABS
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
Delphi

ABS and traction systems · System reference

Scope and connector

Daewoo U-145/173 BL2,3 export ABS EBCM harness connector. The Daewoo manual names DBC 7 in section 4F-3 and labels the connector drawing as a harness end view in section 4F-103. This is a vehicle/export-configuration-specific table, not a generic DBC 7 pinout. C11 is a vent tube, not an electrical terminal.

Documented terminal assignments

TerminalDocumented connection
ABattery supply, hot at all times
BBattery supply, hot at all times
CEBCM ground
DPump motor ground
A3Rear-left wheel-speed sensor high
A4Rear-left wheel-speed sensor low
A5Rear-right wheel-speed sensor low
A6Rear-right wheel-speed sensor high
A7Front-right wheel-speed sensor high
A8Front-right wheel-speed sensor low
A9Front-left wheel-speed sensor low
A10Front-left wheel-speed sensor high
A11Switched ignition
B3Brake warning lamp output
B6Serial data input/output
B8ABS warning lamp output
C3Buffered wheel-speed signal to Siemens ECM
C7Brake switch input
C9PWM rough-road signal to Delphi MR-140 ECM
C11Vent tube; not an electrical contact

Only the listed assignments are included here; omission does not prove a terminal is unused. Compare the source and the exact vehicle wiring diagram before connection or testing. The source describes a specific application or controller variant, not a universal family pinout.

Sources