Eaton Cummins Endurant HD is an electronically controlled automated commercial-vehicle transmission. Its linear clutch actuator and mechatronic transmission module have their own diagnostic paths. It is distinct from Eaton UltraShift PLUS; do not transfer fault-code definitions or service procedures between them. Identify the vehicle, transmission model and serial, module part and serial numbers, software and calibration before applying a bulletin. PACCAR TX-12 is included only where the cited bulletin explicitly names it.
Clutch actuator and release faults
In TAIB-0885, updated December 2024, Eaton Cummins describes an illuminated transmission service lamp and failure to engage a gear from neutral with fault 511, SPN 5614, FMI 7 or 10 on Endurant HD and PACCAR TX-12. Its diagnostic path separates older software, persistent faults after the relevant update, release-yoke pivot-pin condition and actuator type. A 511 entry is therefore not proof that the linear clutch actuator alone needs replacement. Record the exact code and FMI, current controller software, calibration and symptoms, then follow the current manufacturer branch.
The earlier 2020 version of TAIB-0885 applied its historical proactive software and calibration programme to Endurant and PACCAR transmissions at or below serial Z0057102. It specified different packages and configurations for the two applications. That serial condition belongs to the historical programme; use the current bulletin and vehicle-specific support information to determine today's procedure, not an old software number as an instruction to program.
TAIB-0889, updated February 2026 provides a separate release-system inspection for the Endurant HD/XD and PACCAR TX-12/TX-18 cases it specifies: fault 706 SPN 2983 FMI 17 or 18, active or inactive, or referral from TAIB-0885. It distinguishes actual release-yoke, bearing, pivot and clutch damage or measured wear from acceptable condition. HD and XD have different inspection details; inspect and measure under the correct plan instead of replacing an entire clutch from a fault code alone.
Shift-rail air leak example
For specified 12-speed Endurant HD and PACCAR TX-12 mechatronic modules, TAIB-0994 describes loose rail-cylinder cover fasteners that can cause an air leak, shifting complaints and rail-operation fault codes. Applicability depends on the module label, part number and serial number listed in the bulletin; it expressly excludes the 18-speed Endurant XD. If fault 570 or 706 is present, the bulletin directs the technician to diagnose the clutch-release fault first, since it can also accompany rail faults. Follow its separate isolation instruction for fault 617 FMI 14. These are defined bulletin branches, not universal meanings for every transmission.
Workshop approach
- Record the complaint, circumstances, displayed gear and warning, vehicle and transmission identification, module labels, software, air-system condition and any previous clutch or gearbox repairs.
- Save the service activity report and active and inactive codes with SPN and FMI before clearing or programming. Compare the exact combination with the current fault-isolation plan and any applicable bulletin.
- Investigate mechanical release, air supply, wiring and the module only as directed by measured evidence and the relevant branch. A software update does not repair broken hardware or an air leak; a rail fault can have a clutch-release cause.
- Secure and isolate the vehicle and stored pneumatic energy as directed by the manufacturer. Carry out the specified post-repair calibration and verification with the correct equipment and current instructions.
Related: Eaton UltraShift PLUS, ZF AS Tronic and the electronic gearbox index.