Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
MBE Systems standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

MBE Systems identifies the 992 among ECU modules supported by Easimap; SBD treats it as an earlier controller and notes its OBD harness alongside 9A4 and 9A8. Similar plugs do not establish matching functions. Source and identification.

Wiring and pinout

Model wiring documentation: AiM 992 communication diagrams for the exact variant; this is not a complete universal engine pinout. Check connector view, wiring harness, ECU part number and installed calibration before connecting power. Programmable input and output functions depend on the map and software.

Configuration and support

For programmable SBD-supplied ECUs, Easimap is used to inspect and change maps, subject to the interface and access of the actual ECU. Some vehicle-manufacturer supplied units are locked; SBD’s FAQ warns against attempting downloads to locked ECUs. Do not assume that a serial ECU map or harness transfers directly to a newer CAN unit.

Evidence limits

Verify the build, trigger inputs, coil-driver type and software with the supplier. Not all historic variants and pin assignments are documented here.

Documented CAN connections

AiM's MBE integration guide identifies these pins on the 36-way J2 connector for its 992 suppressed, 992 V2 and 992 CAN examples, pages 7, 9 and 12. This is a partial communication schedule; verify the specific ECU and loom.

992 J2 connector: documented CAN pins

J2 pinFunction
8CAN low
9CAN high