The MBE 941 is an older serial ECU; MBE’s serial interface document identifies its main connector and communications signals. It does not establish all engine-control pins for every hardware variant. Source and identification.
Wiring and pinout
Model wiring documentation: MBE serial interface protocol: 941 mapping communications, not a complete application pinout. Check connector view, wiring harness, ECU part number and installed calibration before connecting power. Programmable input and output functions depend on the map and software.
Configuration and support
For programmable SBD-supplied ECUs, Easimap is used to inspect and change maps, subject to the interface and access of the actual ECU. Some vehicle-manufacturer supplied units are locked; SBD’s FAQ warns against attempting downloads to locked ECUs. Do not assume that a serial ECU map or harness transfers directly to a newer CAN unit.
Evidence limits
Verify the build, trigger inputs, coil-driver type and software with the supplier. Not all historic variants and pin assignments are documented here.
Manufacturer serial and mapping connections
MBE Systems' 941 serial-interface document, page 2, identifies these communications and trim positions on the 55-way main connector and mapping interfaces. This is a partial schedule, not the full engine connector. The document identifies Byte Mode and Broadcast Mode as different trim-input configurations.
941AA35x communication and mapping
| Signal | 55-way ECU pin | 9-way ECU / standard harness pin | PC DB9 pin |
|---|---|---|---|
| ECU transmit | 45 | 2 | 2 |
| ECU receive | 46 | 3 | 3 |
| Fuel trim | 47 | 6 | — |
| Ignition trim | 10 | 7 | — |
| Ground | 7 | 1 | 5 |