Haltech IG5: IG5 is a historical programmable ignition controller, listed in Haltech's discontinued manual and software archives. The IG5 manual describes ignition outputs used to trigger an igniter; it does not establish a complete fuel-injection ECU. Manufacturer information.
Identification and connection
Record ECU model, serial, hardware revision, firmware and loom part number before choosing wiring. Select the IG5 manual in the manufacturer's archive. Its documented ignition signals require a suitable igniter, with output configuration matched to its type; the outputs must not be treated as direct coil drivers. Model-specific manual or diagram.
Software and related models
Use the manufacturer's model-appropriate software and documentation. Configuration and available outputs depend on exact hardware and the intended installation. See the manufacturer model index for related systems.
Manufacturer main connector schedule
The 20-way J1 positions are transcribed from Haltech’s IG5 main harness electrical diagram, revision B, dated 15 December 1998. The source labels both pins 1 and 14 “AUX OUT3”, while its separate ignition breakout also lists AUX OUT1; that discrepancy is unresolved. Confirm the exact loom and pin functions with Haltech before wiring. Wire-colour fields in the diagram appear repeated and are not reproduced here as authoritative.
| J1 pin | Function shown on diagram |
|---|---|
| 1 | Aux output 3 |
| 2 | Tachometer |
| 3 | Bypass |
| 4 | Aux input |
| 5 | TX |
| 6 | ECU +13 V DC |
| 7 | Coolant temperature |
| 8 | Home |
| 9 | Trigger |
| 10 | Throttle position |
| 11 | Aux output 4 |
| 12 | Ignition output |
| 13 | Aux output 2 |
| 14 | Aux output 3 |
| 15 | RX |
| 16 | Ground |
| 17 | +5 V DC |
| 18 | Air temperature |
| 19 | Trim |
| 20 | MAP |
J3 nine-way PC interface
| Pin | Function |
|---|---|
| 2 | TX |
| 3 | RX |
| 5 | Ground |
Other PC interface positions are not shown in the diagram.