Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
Autronic standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Autronic SM3 is a standalone or earlier programmable engine-management system. SM3 is described by Autronic as a third-generation ECU with six injector and four ignition outputs. Model-specific information.

Identification and features

Record the ECU label, model, part number, hardware revision, firmware, configured injectors, ignition hardware and loom before comparing systems. Some outputs can be reassigned; hardware, software, current limits and engine-specific options determine what is actually available.

Wiring and pinout

Consult the Autronic SM3 wiring and documentation source and identify the exact connector face, part and version. Do not apply wiring from a similarly named model. If an exact drawing is unavailable for the unit at hand, obtain it from the manufacturer or supplier before making connections.

Further information

SM3 standard loom connector

These 42 positions are transcribed from Autronic SM3 standard loom drawing SM3_0001 revision 1.1. Autronic's wiring index says the drawing also suits SM3 Marine. Connector view is from the wire side. Check the original for wire colours, shared functions, grounding and output limits. The drawing specifies saturated injector drivers and requires ballast for low-impedance injectors, with a minimum 5-ohm load per output.

Correction: A previous revision of this page reversed the pin numbers in the outer two connector rows. The corrected numbering below is checked against Autronic's numbered SM3 input/output function sheet and its standard loom drawing. Confirm connector orientation and actual ECU configuration before wiring.

PinManufacturer function
1Ignition switch input
2Switch input 3
3Switch input 2
4Injector output 5
5Ignition output 1
6Ignition output 2
7Output 1 / stepper
8Analogue input 1
9Coolant temperature input
10HSI input 1
11+8 V trigger supply
12Output 8 / tachometer
13Output 6
14PWM output 2
15+12 V main supply
16Injector output 4
17Injector output 1
18Injector output 6 / switch input 1
19Ignition output 3
20Output 3 / stepper
21Throttle position input
22Sensor ground
23Intake air temperature input
24HSI input 2
25Cylinder trigger positive
26Sync trigger positive
27Output 5
28PWM output 1
29Power supply ground
30+12 V RAM supply
31Injector output 3
32Injector output 2
33Ignition output 4
34Output 2 / stepper
35Output 4 / stepper
36+5 V sensor supply
37Oxygen sensor input
38Analogue input 2 (drawing labels analogue 2–3)
39HSI input 3
40Cylinder trigger negative
41Sync trigger negative
42Output 7