
Sniper 2 is the second generation of Holley's integrated throttle-body EFI system; the ECU and throttle body are a package rather than a generic HP or Terminator module. The 550-511 product information describes updated ECU electronics and a main harness with HyperSpark distributor support.
Wiring and ignition
Holley's system installation diagrams identify a 16-pin main connector, separate CAN and six-pin optional I/O harness for the documented 550-511 arrangement. Its ignition options guide distinguishes a coil-minus RPM-only input from supported timing-control configurations. Verify the specific throttle body, harness, ignition and sensor setup.
See the Holley EFI manufacturer index. Sources reviewed 17 November 2026.
Six-way I/O harness connector
From the Holley Sniper 2 EFI QuickStart guide, for the optional 558-497 I/O harness. Outputs are ground-side relay triggers; consult the guide for current limits and configuration. This table does not document the separate 16-way main connector.
Six-way I/O harness
| Pin | Wire colour | Function |
|---|---|---|
| A | Orange | TPS output, 0–5 V |
| B | Black/yellow | Output 1, ground-switched relay trigger; default fan 1 |
| C | Light blue | Input 2, programmable ground input |
| D | Light green | Input 1, programmable ground input; default IAC kick |
| E | Grey | Tachometer output |
| F | Green/white | Output 2, ground-switched relay trigger; default fan 2 |