Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
MicroTech standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

MicroTech LT-8 is a standalone or earlier programmable engine-management system. Historical LT family model recorded by an Australian tuning workshop; exact engine-specific wiring and hardware version must be identified. Model-specific information.

Identification and features

Record the ECU label, model, part number, hardware revision, firmware, configured injectors, ignition hardware and loom before comparing systems. Some outputs can be reassigned; hardware, software, current limits and engine-specific options determine what is actually available.

Wiring and pinout

Consult the MicroTech LT-8 wiring and documentation source and identify the exact connector face, part and version. Do not apply wiring from a similarly named model. If an exact drawing is unavailable for the unit at hand, obtain it from the manufacturer or supplier before making connections.

Further information

Manufacturer 4-cylinder connector layouts

From MicroTech's LT-8 Mitsubishi/Mazda four-cylinder sequential drawing, revision 1.0 dated 4 October 2004. These tables follow the drawing's ECU view, left to right; the column index is a relative position, not a manufacturer cavity number. Engine, ignition system and loom configuration can vary, so verify the label, drawing and matching ignition sheet for the exact ECU.

6-way connector

Relative column from leftUpper row labelLower row label
1IGN OUTPUT #2IGN OUTPUT #1
2IGN OUTPUT #4IGN OUTPUT #3
3IGN OUTPUT #0 / TACH OUTPUTAUX #2

16-way connector

Relative column from leftUpper row labelLower row label
1AUX OUTPUTAUX INPUT
2INJ OUT #1FUEL PUMP
3INJ OUT #2T.P.S. +5V
4INJ OUT #3WATER TEMP
5INJ OUT #4T.P.S. SIG
6AIR TEMPOXYGEN SENSOR
7GNDGND
8BATTIGN +12V

4-way crank connector

Relative column from leftUpper row labelLower row label
1POWER (RED)CRANK INP 2
2GND (BLACK)CRANK INP 1

The source diagram also depicts the separate MAP sensor port and refers to its second sheet for ignition wiring. The listed arrangement is for this LT-8 drawing and is not proof of wiring for the LT-8S or LTX-8 models.