Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
Electromotive standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Electromotive TECm is a model in the Total Engine Control family. The manufacturer describes TECm as a replacement motherboard for certain mid-1990s BMW Motronic ECUs; confirm the precise factory ECU and application. Manufacturer source.

Identification and software

Identify the exact model, serial, firmware and ignition-driver configuration before using a calibration or connecting a loom. WinTEC versions and hardware vary; the Electromotive manual archive separates the generations.

Wiring and pinout

Consult the model-specific manufacturer source and technical archive for the matching connector, firing order, ECU earths, injector drivers and ignition connections. Do not transfer TECgt200 or TECs200 positions to earlier TEC units. Where a complete exact-model pinout has not been verified, use the manufacturer documentation and verify the actual part number.

Availability

As of 17 November 2026, the manufacturer states it is not selling or repairing products. Electromotive notice. See the Electromotive family reference.

Factory ECU application

The manufacturer identifies TECm as a replacement motherboard for Bosch Motronic 413 and 506 units, including EWS versions, commonly used with specified BMW M50 and S50 applications. It lists six peak-and-hold injector drivers, full sequential injection and WinTEC4 configuration. Confirm original ECU number, engine and harness before ordering or fitting. TECm product specification.

Manufacturer BMW E36 connector schedule

From section 7.4 of the Electromotive TECm hardware manual. NC is reproduced as the manual’s primary-function label: pins 9 and 10 also list alternate functions, so do not interpret the label as a universal electrical disconnection. Wire colours describe the documented vehicle loom; check the original ECU connector, application and configuration.

PinPrimary functionAlternate functionWire colour
1Fuel pump output—Brown/green
2IAC output (inverted)PWM GPOBlack/yellow
3Injector 5 output—Brown/green
4Injector 6 output—Brown/violet
5Injector 4 output—Brown/blue
6Ground—Brown
7Cam timing solenoidPWM GPOGreen/blue
8Check engine light output—Green
9NCPWM GPO—
10NCAnalog GPI—
11NC——
12NC——
13EGO +—Yellow
14Sensor ground—Black
15Ground—Black
16Crank sensor +—Yellow
17Cam sensor +—Yellow
18NC——
19NC——
20NC——
21NC——
22NC——
23Coil 4 output—Black/blue
24Coil 6 output—Black/violet
25Coil 5 output—Black/green
26+12 V switched—Red
27ECU relay control—Brown
28Sensor ground—Brown/orange
29IAC outputPWM GPOBlack/green
30NC——
31Injector 3 output—Brown/yellow
32Injector 2 output—Brown/red
33Injector 1 output—Brown/white
34Ground—Brown
35NC——
36Evaporative solenoid outputPWM GPOBrown
37NC——
38O2 sensor heater control—Brown/green
39NC——
40EGO −—Black
41MAF inputMAP inputGrey/yellow
42Speed inputOn/off GPIBlack/white
43Crank sensor −—Black
44Sensor ground—Brown
45Shield ground—Bare
46Fuel consumption gauge output—White/black
47Tachometer output—Black
48A/C compressor outputPWM GPOBlack/blue
49NC——
50Coil 1 output—Black/white
51Coil 2 output—Black/red
52Coil 3 output—Black/yellow
53NC——