Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
MicroTech standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

MicroTech LT-9c is a standalone or earlier programmable engine-management system. LT-9c has four high-impedance injector and four ignition drivers. Manufacturer specification identifies support for up to four cylinders or two rotors, subject to configuration. Model-specific information.

Identification and features

Record the ECU label, model, part number, hardware revision, firmware, configured injectors, ignition hardware and loom before comparing systems. Some outputs can be reassigned; hardware, software, current limits and engine-specific options determine what is actually available.

Wiring and pinout

Consult the MicroTech LT-9c wiring and documentation source and identify the exact connector face, part and version. Do not apply wiring from a similarly named model. If an exact drawing is unavailable for the unit at hand, obtain it from the manufacturer or supplier before making connections.

Further information

Manufacturer shared connector drawing

MicroTech's LT9/10 wiring archive states that LT-9c and LT-10 use the same wiring diagrams. The example below is from its LT-10 4-cylinder sequential/direct-fire drawing, revision 1.0, 4 October 2004; other engine and ignition configurations are linked in the archive. Columns are relative positions left to right in the drawing's ECU view, not manufacturer pin numbers, which the diagram does not provide. Check the exact unit and engine-specific loom with MicroTech before wiring.

The drawing's injector loading examples are for its LT-10 configuration; they do not establish LT-9c driver ratings. Check the LT-9c manufacturer's specifications and the actual injectors separately.

24-way main connector

Relative column from leftUpper rowLower row
1IGN OUTPUT #2IGN OUTPUT #1
2IGN OUTPUT #4IGN OUTPUT #3
3AUX OUT #3TACH OUTPUT
4AUX OUT #2AUX INPUT #2
5AUX OUT #1AUX INPUT #1
6INJ OUT #1FUEL PUMP
7INJ OUT #2T.P.S. +5V
8INJ OUT #3WATER TEMP
9INJ OUT #4T.P.S. SIG
10AIR TEMPOXYGEN SENSOR
11GNDGND
12BATTIGN +12V

4-way crank connector shown in the same drawing

Relative column from leftUpper rowLower row
1POWER N/C (drawing label)CRANK INP 2
2GNDCRANK INP 1

Ignition trigger wiring varies with the engine and hardware; use the ignition page and model-specific diagram from the manufacturer archive.