
Electromotive TEC-II is a model in the Total Engine Control family. Earlier TEC engine and ignition control unit; the manufacturer groups its installation and calibration manual with TEC-1. Manufacturer source.
Identification and software
Identify the exact model, serial, firmware and ignition-driver configuration before using a calibration or connecting a loom. WinTEC versions and hardware vary; the Electromotive manual archive separates the generations.
Wiring and pinout
Consult the model-specific manufacturer source and technical archive for the matching connector, firing order, ECU earths, injector drivers and ignition connections. Do not transfer TECgt200 or TECs200 positions to earlier TEC units. Where a complete exact-model pinout has not been verified, use the manufacturer documentation and verify the actual part number.
Availability
As of 17 November 2026, the manufacturer states it is not selling or repairing products. Electromotive notice. See the Electromotive family reference.
Documented injector and auxiliary connections
Electromotive’s TEC-I / TEC-II installation manual describes these connections for the four- and six-cylinder TEC-II. This is a partial schedule, not a complete ECU pinout. Pin numbers repeat across different connector groups: identify the group and hardware version before wiring. The eight-cylinder version uses a separate five-pin injector connector.
Four- and six-cylinder injector outputs
| Pin | Function |
|---|---|
| 11 | Injector 1 (coil A group) |
| 12 | Injector 2 (coil C group); not used on standard four-cylinder configuration |
| 13 | Injector 3 (coil B group) |
| 14 | Injector common +12 V |
Idle air control connections described in Honda TEC-II supplement
| Pin | Function | Example IAC wire |
|---|---|---|
| 1 | ISMA | Red |
| 2 | ISMB | Black |
| 3 | ISMC | Green |
| 4 | ISMD | White |
Communications terminals described in the supplement
| Pin | Function |
|---|---|
| 12 | GND |
| 13 | TXD |
| 14 | RXD |