Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Tuning
Parent
Bosch LH-Jetronic
Applies to
Bosch LH-Jetronic
Tool groups
None
Manufacturers
Volvo

Selected Volvo redblock engines use Bosch LH 2.4 fuel injection with a separate EZ116K ignition controller. This guide covers sourced examples, not all 200, 700 or 900 models: other years, markets and conversions use different systems. Identify both installed controllers and their software before choosing a calibration.

Fuel and ignition are separate

The workshop description for a 1994 Volvo 940 B230FT identifies LH2.4 multi-point injection working with EZ116K. In a 1991 940 SE B230FT example, the ignition control uses an engine-speed/load map and knock control; if knock persists after timing correction, the documented system can request mixture enrichment. A fuel-controller change therefore does not itself replace a properly matched ignition calibration.

Record engine, turbo hardware, gearbox, market, fuel, each Bosch and Volvo ECU number and the chip/software identity. An ECU label or matching connector does not establish that a binary, ignition module or hardware is interchangeable. Volvo documents EPROM replacement for selected 1991–1993 940s, so identify the installed calibration as well as the outer label. For context on other systems see Volvo ECU identification.

Definitions and calibration research

The TunerPro definition index lists a community XDF for the Volvo 940 B230FT automatic ECU 0 280 000 954, and separately lists a -937 example for the 740 Turbo. It also lists an EZK -208 definition for a B204FT/GT example. These are the index's application claims and separate definitions, not a verified map pack for all LH 2.4 or all EZK units. Match the exact binary and definition, then check map location, axes, units and conversion before relying on a display. XDF availability does not prove a diagnostic datastream or a programming method.

The original fuel and spark tuning discussion is a research lead; at the time of review the link redirected to the forum homepage, so the contents and attachments were not verified. Community LH 2.4 diagnostic notes provide another entry point. File ownership, chip hardware, software and tool documentation still need checking.

Baseline and diagnostic checks

On selected early cars, the community diagnostic notes describe an under-hood test box where socket 2 reads fuel-controller faults and socket 6 reads ignition faults. Later versions may have a different connector; confirm the exact car. Record faults from both systems before clearing and follow the vehicle procedure.

The 1994 B230FT LH2.4 service description identifies a throttle switch and ECU-controlled idle and fuel-cut behaviour. Check the idle/full-load switch, intake leaks, air-mass meter, fuel pressure, lambda feedback and ignition health before attributing poor running to a map. Record boost, RPM and a correctly installed calibrated wideband alongside available ECU data; actual boost and lambda are not interchangeable with the ECU's calculated load or narrowband correction.

Volvo's ignition system manual describes the LH fuel controller sending its air-mass-based load information to the separate ignition controller. Injector or MAF housing changes affect the fuel calculation and can affect the load information exchanged with ignition. Confirm the transfer function, injector flow and opening-time data, operating pressure, knock response and actual mixture across the operating range. The vehicle sources above do not validate a universal injector constant, boost target or file.