
Link G4X WRX9X is a vehicle-specific programmable plug-in ECU for the Subaru WRX version 7–9 application listed in Link's model-specific manuals index. It is an application board, rather than the universal wire-in ECU. Check the exact vehicle, market, engine, original ECU and board part number against the manufacturer's WRX9X installation manual.
Identification and installation
Record the Link model label and revision, donor factory ECU connector and car's engine and year. Plug-in boards connect to particular factory-harness layouts; the family or vehicle name alone does not establish every model-year or transmission combination. The manufacturer manual gives the supported application and any installation or configuration notes for this board.
G4X plug-in platforms offer configurable fuel and ignition control but available channels and features depend on the original header and board. The G4X plug-in general specifications are conditional on the particular application and do not mean every input is brought out to the factory harness.
Pinout and tuning
The WRX9X installation manual is the model-specific source for board pinouts, expansion connections, electrical cautions and startup configuration. Use its connector orientation and the exact board version; do not copy a wire-in ECU pinout onto a factory harness. PCLink and manual downloads; Link manufacturer overview.
Manufacturer connector schedules
From Link's WRX9X installation manual (2025). Link states that its pinouts are viewed looking into the ECU from the wire side. A dash reproduces an unspecified source field; nc is Link's label. Applies to the V7–9 WRX/STi layouts documented by Link. On some Australian-market vehicles pin D11 controls the alternator instead of intercooler spray; the spray is controlled separately and pin B12 is not connected. Configure the sample map for the actual vehicle.
Factory main header positions
| Factory pin | Link ECU channel | Factory function |
|---|---|---|
| A-1 | DI 5 | Vehicle Speed |
| C-21 | Ignition 4 | Ignition |
| A-2 | Main Relay (WRX) / DI 3 (STI) | Main Relay Control (WRX) / A/C Request (STI) |
| C-22 | Ignition 3 | Ignition |
| A-3 | DI 10 | Rear de-mist switch |
| C-23 | Ignition 2 | Ignition |
| A-4 | nc | — |
| C-24 | Ignition 1 | Ignition |
| A-5 | Ignition Switch (STI) | Controls Main Relay |
| A-6 | DI 3 (WRX) / Main Relay (STI) | A/C Request (WRX) / Main Relay Control (STI) |
| D-1 | Injector 1 | Injection |
| A-7 | Ground | — |
| D-2 | +14V Main Relay | ECU Power |
| A-8 | nc | — |
| D-3 | +14V Main Relay | ECU Power |
| A-9 | nc | — |
| D-4 | nc | — |
| A-10 | nc | — |
| D-5 | nc | — |
| A-11 | nc | — |
| D-6 | nc | — |
| A-12 | nc | — |
| D-7 | nc | — |
| A-13 | nc | — |
| D-8 | Ground | — |
| A-14 | Ignition Switch (WRX) | Controls Main Relay |
| D-9 | Ground | — |
| A-15 | Ground | — |
| D-10 | nc | — |
| A-16 | DI 6 | Start Signal |
| D-11 | Injector 6 (Aux) | IC Spray Relay* |
| A-17 | nc | — |
| D-12 | nc | — |
| A-18 | nc | — |
| D-13 | nc | — |
| A-19 | nc | — |
| D-14 | An Temp 3 | IAT (Spec C) |
| A-20 | nc | — |
| D-15 | Aux 5 | CE Light |
| A-21 | nc | — |
| D-16 | nc | — |
| A-22 | Ground | — |
| D-17 | Injector 5 (Aux) | Engine Fan |
| D-18 | Ground (O2 Shield) | — |
| B-1 | Trig 2 | Trig 2 |
| D-19 | nc | — |
| B-2 | Trig 1 | Trig 1 |
| D-20 | nc | — |
| B-3 | nc | — |
| D-21 | nc | — |
| B-4 | Knock 1 | Knock |
| D-22 | nc | — |
| B-5 | nc | — |
| D-23 | nc | — |
| B-6 | nc | — |
| D-24 | Aux 6 | Boost Solenoid |
| B-7 | An Volt 3 | TPS (Main) |
| D-25 | nc | — |
| B-8 | An Volt 1 | MAP Sensor |
| D-26 | nc | — |
| B-9 | +5V Out | — |
| D-27 | Injector 7 (Aux) | A/C Clutch Relay |
| B-10 | Ground (Trig 2) | — |
| D-28 | Injector 8 (Aux) | A/C Fan Relay |
| B-11 | Ground (Trig 1) | — |
| D-29 | nc | — |
| B-12 | DI 4 | IC Spray Switch |
| D-30 | nc | — |
| B-13 | nc | — |
| D-31 | nc | — |
| B-14 | nc | — |
| B-15 | nc | — |
| E-1 | Ground | — |
| B-16 | nc | — |
| E-2 | DI 2 | Bank 1 Inl Cam Pos |
| B-17 | An Volt 4 | Rear O2 Signal |
| E-3 | Ground (Cam Pos) | — |
| B-18 | An Temp 2 | ECT |
| E-4 | +14V Out (TGV) | — |
| B-19 | Ground (Signal) | — |
| E-5 | Ground (TGV) | — |
| B-20 | nc | — |
| E-6 | +14V Out (Cam) | — |
| B-21 | Ground (Shield) | — |
| E-7 | Ground (AFM) | — |
| B-22 | Ground (Shield) | — |
| E-8 | Ground (AFM Shield) | — |
| B-23 | nc | — |
| E-9 | DI 1 | Bank 2 Inl Cam Pos |
| B-24 | An Volt 5 | Power Steer Switch |
| E-10 | +14V Out (TGV) | — |
| B-25 | nc | — |
| E-11 | Ground (TGV) | — |
| B-26 | Ground (Shield) | — |
| E-12 | Aux 2 | Bank 1 Inl AVCS Sol |
| B-27 | An Temp 1 | IAT (AFM) |
| E-13 | An Volt 2 | AFM Signal |
| B-28 | nc | — |
| E-14 | Ground (Cam Shield) | — |
| E-15 | Ground (Cam Pos) | — |
| C-1 | nc | — |
| E-16 | Aux 1 | Bank 2 Inl AVCS Sol |
| C-2 | nc | — |
| E-17 | +14V Out (Cam) | — |
| C-3 | nc | — |
| C-4 | Injector 4 | Injection |
| C-5 | Injector 3 | Injection |
| C-6 | Injector 2 | Injection |
| C-7 | nc | — |
| C-8 | Ground | — |
| C-9 | Ignition 5 (Aux) | Tacho |
| C-10 | Aux 3 | ISC Solenoid |
| C-11 | nc | — |
| C-12 | nc | — |
| C-13 | Aux 8 | Rear O2 Heater |
| C-14 | nc | — |
| C-15 | Aux 7 | FP Speed Control |
| C-16 | Aux 7 | FP Speed Control |
| C-17 | Ground | — |
| C-18 | Ground | — |
| C-19 | nc | — |
| C-20 | nc | — |
Expansion connector
| Pin | Link ECU channel | Factory function |
|---|---|---|
| 1 | Ignition 6 (Aux) | — |
| 2 | Ignition 7 (Aux) | — |
| 3 | Ignition 8 (Aux) | — |
| 4 | DI 7 | — |
| 5 | DI 8 | — |
| 6 | DI 9 | — |
| 7 | An temp 4 | — |
| 8 | An Volt 11 | — |
| 9 | Ground (Signal) | — |
| 10 | +5V Out | — |
| 11 | Aux 9 | — |
| 12 | Aux 10 | — |
| 13 | An Volt 6 | — |
| 14 | An Volt 7 | — |
| 15 | An Volt 9 | — |
| 16 | An Volt 10 | — |
CAN 1/RS232 Connector
| Pin | Function | Wire colour |
|---|---|---|
| 1 | Comms GND | Brown |
| 2 | CAN1 L | Green |
| 3 | CAN1 H | White |
| 4 | RS232-RX | Grey |
| 5 | RS232-TX | Yellow |
CAN 2/OBD Connector
| Pin | Function | Wire colour |
|---|---|---|
| 1 | GND | Brown |
| 2 | CAN2 L | Green |
| 3 | CAN2 H | White |
| 4 | NC | Grey |
| 5 | +14V | Yellow |