Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
Vi-PEC standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Vi-PEC iSupra is a iSeries plug-in ECU documented for Toyota Supra 2JZ non-VVT. It is a vehicle-specific replacement board, and the precise model year, engine, ECU connector and market variant must be checked against the installation guide. Link's Vi-PEC manual index.

Installation and pin functions

Use the specific Vi-PEC installation manual for this application. Its installation instructions and pin-function sections identify connections and application differences; a similarly named iSeries plug-in board for another vehicle must not be used as a wiring reference. Check the original ECU part number and wiring before fitting.

Programming and support

Link identifies PCLink G4+ for iSeries hardware. Firmware compatibility and the calibration depend on the ECU version. Consult the software archive and retain the original calibration before any change.

Identification limits

This page is indexed by the documented application rather than an independently verified manufacturer SKU. Check the manual for exact compatibility and do not infer additional vehicle fitments.

Manufacturer pinout tables

These are all positions listed in the application-specific Vi-PEC installation guide, page 20. The guide specifies the view looking into the ECU from the wire side. Positions omitted by the guide are not assumed unused; functions must be configured for the vehicle. The guide names Toyota Supra 92–97 in the pinout section and 93–98 2JZ-GTE in its function listing. Both B71 and B72 are labelled Inj 7 in the pinout, while the function list also mentions Inj 8; confirm the correct assignment and exact car before wiring.

Main ECU connector: documented positions

PositionECU function
A1DI 2
B43An Volt 5
A2DI 1
B44An Temp 1
A4DI 6
B45An Temp 2
A6Ign 7
B47An Volt 4
A15DI 4
B48An Volt 3
A16Aux 1
B49Knock 2
A22Aux 2
B50Knock 1
A23Aux 3
B52Ign 6
A34DI 3
B53Ign 5
B15Inj 6
B54Ign 4
B16Inj 5
B55Ign 3
B17Inj 4
B56Ign 2
B18Inj 3
B57Ign 1
B19Inj 2
B60Aux 4
B20Inj 1
B62An Volt 1
B25Trig 2
B65Sensor GND
B27Trig 1
B66An Volt 2
B32Aux 8
B71Inj 7
B33Aux 6
B72Inj 7
B34Aux 7
B73Ign 8
B35Aux 5
B74Aux 10
B41+5 Volt out
B76DI5

Expansion connector functions

The guide also lists sensor ground, low-current +5 V, An Volt 6 and 7, An Temp 3 and 4, and DI 7 and 8 on the expansion connector, but does not assign cavity numbers in this section. Do not infer their order.