Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
Syvecs Standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None
Syvecs S7Plus general-purpose ECU
Syvecs S7Plus general-purpose ECU shown as a family reference; vehicle-specific kit and adaptor may differ. Manufacturer photograph, reproduced with permission. Image source.

Model and vehicle application

Syvecs lists this vehicle-specific standalone or plug-in ECU kit as Can-Am Maverick X3 2021-2023, with product code S7Plus-CanAmDF21. The product page and its stated vehicle, model and transmission details define this particular application; confirm market, model year, engine, ECU connector and transmission against Syvecs before ordering.

This entry describes the dedicated vehicle kit. It is distinct from the generic wire-in ECU: a plug-in kit can use application-specific adaptor wiring, a carrier, additional modules and an application calibration. The listed hardware or supported equipment can vary by revision.

Wiring and pinout

Syvecs Can-Am Maverick X3 2021-2023 installation and wiring document. Follow the connector orientation, application-specific tables, installation notes and hardware revision in this document. Do not transfer assignments from another vehicle merely because the underlying ECU family is similar. The link was checked to return a PDF.

For other variants and manual revisions consult the manufacturer's vehicle-specific manual index. Available spare inputs and outputs can be used only within their electrical limits and with a matching calibration.

Calibration and service

Use the correct Syvecs software, firmware and base calibration for the exact vehicle and installed hardware. The Syvecs software portal and firmware archive provide manufacturer support. A base map is a starting point and needs checking against the actual engine, injectors, sensors and modifications.

Sources

Additional I/O connector

The Syvecs 2021–2023 Can-Am installation manual, page 7, documents the following 26-way connector on the rear of the ECU. Pins 18–19 default to CAN3 according to the guide; verify the exact configuration and connector orientation before wiring. This is the additional I/O connector, not a complete factory vehicle connector pinout.

PinFunction
1Ground
2HBR5
3HBR6
4Fuel 8
5Fuel 7
6Fuel 6
7Vbat
8Lambda 1 heater
9Lambda 1 A
10Lambda 1 B
11Lambda 1 D
12RS232 RX
13RS232 TX
14AN12
15AN13
16HBR3
17+5 V
18EGT− / CAN3 L
19EGT+ / CAN3 H
20Analogue ground
21CAN2 H
22CAN2 L
23LAN RX−
24LAN RX+
25LAN TX−
26LAN TX+