Adaptronic eSel030 is a Select-series vehicle plug-in programmable engine-management ECU. The surviving manufacturer guide identifies the intended application as Toyota SW20 MR2 (1989–1991) with distributor-type 3S-GTE. Adaptronic eSel030 application and installation guide.
Identification and application
Confirm the case label and part number, original ECU and loom connector, engine, market and any vehicle-specific equipment against the guide before purchase or installation. Vehicle wiring can vary, and a shared plug shape does not establish pin compatibility.
Software and installation
The Select family uses Adaptronic WARI software, which is listed in Haltech’s legacy Adaptronic downloads archive. Use the matching eSel030 guide and application-specific basemap; the guide documents installation, configuration and pin references. A plug-in ECU still requires configuration and tuning for the actual engine and equipment.
Wiring and pinout
The manufacturer eSel030 guide contains the model and application-specific connector information. Positions and functions can change by application, and factory function and Adaptronic function are separate columns in the guide. The manufacturer connector table is transcribed below; verify the source and viewpoint before use.
Support and sources
Haltech states that Adaptronic operations ended in 2022. Refer to its Adaptronic notice and archived guides, and confirm current support and compatibility for used hardware. A verified product photograph for this exact part has not yet been added.
Manufacturer connector table
From the Adaptronic eSel030 installation guide, pages 20–21. These are the manufacturer-listed positions; a blank entry is represented by a dash. NC in the factory column refers to the factory loom, not necessarily an unused Adaptronic input or output. Verify the application and connector orientation in the original guide.
| Factory pin label | Adaptronic connector pin | Factory function | Factory colour | Adaptronic function | Comments |
|---|---|---|---|---|---|
| BATT | 1A | Battery | White/Red | — | — |
| +B1 | 1B | EFI main relay | Black/Yellow | — | — |
| ELS | 1C | Headlight/defogger | Black | Dig in 3 (electrical load) | — |
| +B | 1D | EFI main relay | Black/Yellow | +12V ignition | — |
| none/EGW | 1E | NC/Exhaust temperature | Red | — | — |
| PSCT | 1F | Power steering ECU | Blue/Yellow | Aux 8 (ground when RPM<500) | — |
| STP | 1G | Stop light switch | Green/White | Dig in 5 (electrical load) | — |
| PS | 1H | Power steering ECU | Black | Dig in 4 (electrical load) | — |
| W | 1I | Check Engine Light | Green/White | Aux 6 | — |
| none/CCO | 1J | Check connector | Pink | — | — |
| FPR | 1K | Fuel pump relay | Blue/Red | Aux 7 | — |
| - | 1L | NC | — | — | — |
| - | 1M | NC | — | SVSS1 | — |
| - | 1N | NC | — | SVSS2 | — |
| ABS | 1O | ABS ECU | Green/Yellow | Aux 8 (ground when RPM<500) | — |
| - | 1P | NC | — | — | — |
| SPD | 1Q | Speed sensor | Purple/White | MVSS1 | — |
| - | 1R | NC | — | MVSS2 | — |
| AC1 | 1S | A/C magnet switch | Black/White | Dig in 2 (AC Request, act high) | — |
| - | 1T | NC | — | — | — |
| STA | 1U | Starter switch | Red | — | — |
| - | 1V | NC | — | — | — |
| VC | 3A | Sensor power source | Red/Blue | MAP +5V or TPS +5V | — |
| E2 | 3B | Sensor Ground | Brown | MAP GND or TPS GND | SGND |
| VS | 3C | AFM | Yellow/Blue | ExtIn | — |
| THG | 3D | EGR gas temp sensor | Black/Yellow (X) | AuxTemp | — |
| THA 1 | 3E | Air temp (inside AFM) | Black | MAT | — |
| VTA | 3F | TPS | White | TPS sig | — |
| THW | 3G | Water temp sensor | Red | ECT | — |
| IDL | 3H | TPS | Pink | Dig in 1 (closed throttle) | — |
| KNK | 3I | Knock sensor | Black | Knock | — |
| PIM | 3J | Turbo pressure sensor | Blue/Black | MAP sig | — |
| OX1 | 3K | Main oxygen sensor | Black | EGO | O2 |
| OX2 | 3L | Sub oxygen sensor | Black | — | — |
| - | 3M | NC | — | Dig in 6 | — |
| T | 3N | Check connector | Orange | Dig in 7 | — |
| VF | 3O | Check connector | Red/White | Dig in 8 | — |
| G- | 3P | Distributor | Red | CAS ground | SGND |
| NE | 4A | Distributor | Black | Trig 1 | CAS1 |
| E1 | 4B | Engine Ground | Brown | PGND | — |
| G2 | 4C | Distributor | Green | Trig 2 | CAS2 |
| G1 | 4D | Distributor | White | Trig 3 | CAS3 |
| IGF | 4E | Igniter (feedback) | White/Red | — | — |
| - | 4F | NC | — | — | — |
| - | 4G | NC | — | — | — |
| FC | 4H | Circuit opening relay | Green/Red | Aux 5 | — |
| - | 4I | NC | — | — | — |
| TVIS | 4J | T-VIS VSV | Green/Black | Aux 1 | — |
| TPC1 | 4K | Turbo pressure VSV | Blue/Orange | Aux 2 (boost control) | — |
| - | 4L | NC | — | Ign2 | — |
| - | 4M | NC | — | Ign3 | — |
| IGT | 4N | Igniter | White | Ign1 | — |
| HT | 4O | Oxygen sensor heater | Red/White (X) | PGND | — |
| - | 4P | NC | — | Ign4 | — |
| RSC | 4Q | ISC valve | Red | Aux 4 | — |
| RSO | 4R | ISC valve | Green | Aux 3 | — |
| STJ | 4S | Cold start injector | Green (X) | — | — |
| EGR | 4T | EGR valve | Red (X) | — | — |
| No.2 | 4U | Injector 2 | White/Blue | Inj4 | — |
| No.4 | 4V | Injector 4 | Green/Yellow | Inj3 | — |
| No.1 | 4W | Injector 1 | Red/White | Inj1 | — |
| No.3 | 4X | Injector 3 | Black/White | Inj2 | — |
| E01 | 4Y | Power Ground | Brown | PGND | — |
| E02 | 4Z | Power Ground | Brown | PGND | — |