Page organisation in this revision
- Page type
- Technical article
- Subject
- CAN bus
- Parent
- Section level
- Applies to
- No ECU-specific applicability
- Tool groups
- None
- Manufacturers
- Mercedes-Benz
Changes from revision 1 to revision 1
Removed text is struck through; added text is highlighted.
Mercedes-Benz vehicles from the W203/W211 generation through the W204/W212 era use a dual-CAN architecture separated by the Electronic Ignition Switch (EIS/EZS) or Central Gateway (CGW):
CAN-C (Engine / Chassis / Powertrain CAN): 500 kbit/s differential two-wire CAN linking ME/CDI Engine ECU, ETC/7G-Tronic TCU, ESP/SBC, ISM, Steering Angle Sensor, and Radar/Distronic.
CAN-B (Interior / Body CAN): 83.3 kbit/s (earlier W203/W211) or 125 kbit/s (later W204/W212) fault-tolerant bus linking SAMs, doors, seats, climate control, and comfort modules.
CAN-E / CAN-F / FlexRay: Added on W212/W221+ for chassis, ADAS, and central display integration.
Mercedes-Benz E350 (W212 / 2010) Chassis & Powertrain CAN IDs
Compiled from opendbc mercedes_benz_e350_2010.dbc. Bit positions use DBC numbering (@BE = Motorola big-endian, @LE = Intel little-endian).
Hex ID
Decimal
Name
DLC
Signals, DBC Bits & Scaling
0x0033STEER_SENSOR8STEER_ANGLE (3|12@BE-, ×−0.5°), STEER_DIRECTION (bit 4: 0=left, 1=right), STEER_RATE (19|12@BE-, ×0.5), Counter (55|4), Checksum (63|8)
0x0055BRAKE_MODULE8BRAKE_PRESSED (0|1@LE+), BRAKE_HOLD (bit 2), DRIVER_BRAKE (bit 4), COMPUTER_BRAKE (bit 10), BRAKE_POSITION (17|10@BE+)
0x00E14STEER_TORQUE8STEER_TORQUE (15|8@BE+), Counter (55|4), Checksum (63|8)
0x04569DRIVER_CONTROLS8Cruise stalk bits (bits 0–5: Cancel, Resume, Accel High/Low, Decel High/Low), Left/Right blinkers (bits 16–17), High beam toggle/flash (bits 18–19), Steering wheel buttons (32|16@LE+)
0x06D109GEAR_LEVER8REVERSE (bit 8), NEUTRAL_UP (bit 9), NEUTRAL_DOWN (bit 10), DRIVE (bit 11), PARK_BUTTON (bit 12)
0x073115GEAR_PACKET8GEAR (0|4@LE+)
0x101257CRUISE_CONTROL8LONGITUDINAL_ACCEL_REQUEST (15|8@BE-), CRUISE_ACCELERATING (bit 22), CRUISE_DISABLED (bit 23)
0x104260CRUISE_CONTROL28Secondary cruise / Distronic frame with counter and checksum
0x105261GAS_PEDAL8ENGINE_RPM (4|5@BE+ scaled/compressed field), COMBINED_GAS (31|8@BE+), GAS_PEDAL (39|8@BE+)
0x133307POWER_SEATS8Driver seat forward/back switch bits (bits 0–1)
0x201513WHEEL_ENCODERS8Wheel tick encoders 1–4 (8-bit each: 7|8, 15|8, 23|8, 31|8)
0x203515WHEEL_SPEEDS8Wheel moving flags (bits 6, 22, 38, 54); 11b BE+ wheel speeds (×0.0375 mph): FL (2|11), FR (18|11), RL (34|11), RR (50|11)
0x245581IGNITION8Ignition / EIS terminal state
0x283643DOOR_SENSORS8Door open/closed bits FL/FR/RL/RR (bits 0–7), Brake pressed (bit 27)
0x375885SEATBELT_SENSORS8SEATBELT_DRIVER_LATCHED (bit 16), SEATBELT_PASSENGER_LATCHED (bit 18)
0x378888CRUISE_CONTROL38CRUISE_SET_SPEED (15|8@BE+, mph), CRUISE_ENABLED (bit 34), CRUISE_DISABLED (bit 36)
Sources
commaai/opendbc — mercedes_benz_e350_2010.dbc. Accessed 2026-11-17.
Rendered revisions
Open each version to inspect formatting, tables and photographs.
Revision 1: Mercedes-Benz CAN bus systems and CAN IDs
Mercedes-Benz vehicles from the W203/W211 generation through the W204/W212 era use a dual-CAN architecture separated by the Electronic Ignition Switch (EIS/EZS) or Central Gateway (CGW):
- CAN-C (Engine / Chassis / Powertrain CAN): 500 kbit/s differential two-wire CAN linking ME/CDI Engine ECU, ETC/7G-Tronic TCU, ESP/SBC, ISM, Steering Angle Sensor, and Radar/Distronic.
- CAN-B (Interior / Body CAN): 83.3 kbit/s (earlier W203/W211) or 125 kbit/s (later W204/W212) fault-tolerant bus linking SAMs, doors, seats, climate control, and comfort modules.
- CAN-E / CAN-F / FlexRay: Added on W212/W221+ for chassis, ADAS, and central display integration.
Mercedes-Benz E350 (W212 / 2010) Chassis & Powertrain CAN IDs
Compiled from opendbc mercedes_benz_e350_2010.dbc. Bit positions use DBC numbering (@BE = Motorola big-endian, @LE = Intel little-endian).
| Hex ID |
Decimal |
Name |
DLC |
Signals, DBC Bits & Scaling |
0x003 | 3 | STEER_SENSOR | 8 | STEER_ANGLE (3|12@BE-, ×−0.5°), STEER_DIRECTION (bit 4: 0=left, 1=right), STEER_RATE (19|12@BE-, ×0.5), Counter (55|4), Checksum (63|8) |
0x005 | 5 | BRAKE_MODULE | 8 | BRAKE_PRESSED (0|1@LE+), BRAKE_HOLD (bit 2), DRIVER_BRAKE (bit 4), COMPUTER_BRAKE (bit 10), BRAKE_POSITION (17|10@BE+) |
0x00E | 14 | STEER_TORQUE | 8 | STEER_TORQUE (15|8@BE+), Counter (55|4), Checksum (63|8) |
0x045 | 69 | DRIVER_CONTROLS | 8 | Cruise stalk bits (bits 0–5: Cancel, Resume, Accel High/Low, Decel High/Low), Left/Right blinkers (bits 16–17), High beam toggle/flash (bits 18–19), Steering wheel buttons (32|16@LE+) |
0x06D | 109 | GEAR_LEVER | 8 | REVERSE (bit 8), NEUTRAL_UP (bit 9), NEUTRAL_DOWN (bit 10), DRIVE (bit 11), PARK_BUTTON (bit 12) |
0x073 | 115 | GEAR_PACKET | 8 | GEAR (0|4@LE+) |
0x101 | 257 | CRUISE_CONTROL | 8 | LONGITUDINAL_ACCEL_REQUEST (15|8@BE-), CRUISE_ACCELERATING (bit 22), CRUISE_DISABLED (bit 23) |
0x104 | 260 | CRUISE_CONTROL2 | 8 | Secondary cruise / Distronic frame with counter and checksum |
0x105 | 261 | GAS_PEDAL | 8 | ENGINE_RPM (4|5@BE+ scaled/compressed field), COMBINED_GAS (31|8@BE+), GAS_PEDAL (39|8@BE+) |
0x133 | 307 | POWER_SEATS | 8 | Driver seat forward/back switch bits (bits 0–1) |
0x201 | 513 | WHEEL_ENCODERS | 8 | Wheel tick encoders 1–4 (8-bit each: 7|8, 15|8, 23|8, 31|8) |
0x203 | 515 | WHEEL_SPEEDS | 8 | Wheel moving flags (bits 6, 22, 38, 54); 11b BE+ wheel speeds (×0.0375 mph): FL (2|11), FR (18|11), RL (34|11), RR (50|11) |
0x245 | 581 | IGNITION | 8 | Ignition / EIS terminal state |
0x283 | 643 | DOOR_SENSORS | 8 | Door open/closed bits FL/FR/RL/RR (bits 0–7), Brake pressed (bit 27) |
0x375 | 885 | SEATBELT_SENSORS | 8 | SEATBELT_DRIVER_LATCHED (bit 16), SEATBELT_PASSENGER_LATCHED (bit 18) |
0x378 | 888 | CRUISE_CONTROL3 | 8 | CRUISE_SET_SPEED (15|8@BE+, mph), CRUISE_ENABLED (bit 34), CRUISE_DISABLED (bit 36) |
Sources
Revision 1: Mercedes-Benz CAN bus systems and CAN IDs
Mercedes-Benz vehicles from the W203/W211 generation through the W204/W212 era use a dual-CAN architecture separated by the Electronic Ignition Switch (EIS/EZS) or Central Gateway (CGW):
- CAN-C (Engine / Chassis / Powertrain CAN): 500 kbit/s differential two-wire CAN linking ME/CDI Engine ECU, ETC/7G-Tronic TCU, ESP/SBC, ISM, Steering Angle Sensor, and Radar/Distronic.
- CAN-B (Interior / Body CAN): 83.3 kbit/s (earlier W203/W211) or 125 kbit/s (later W204/W212) fault-tolerant bus linking SAMs, doors, seats, climate control, and comfort modules.
- CAN-E / CAN-F / FlexRay: Added on W212/W221+ for chassis, ADAS, and central display integration.
Mercedes-Benz E350 (W212 / 2010) Chassis & Powertrain CAN IDs
Compiled from opendbc mercedes_benz_e350_2010.dbc. Bit positions use DBC numbering (@BE = Motorola big-endian, @LE = Intel little-endian).
| Hex ID |
Decimal |
Name |
DLC |
Signals, DBC Bits & Scaling |
0x003 | 3 | STEER_SENSOR | 8 | STEER_ANGLE (3|12@BE-, ×−0.5°), STEER_DIRECTION (bit 4: 0=left, 1=right), STEER_RATE (19|12@BE-, ×0.5), Counter (55|4), Checksum (63|8) |
0x005 | 5 | BRAKE_MODULE | 8 | BRAKE_PRESSED (0|1@LE+), BRAKE_HOLD (bit 2), DRIVER_BRAKE (bit 4), COMPUTER_BRAKE (bit 10), BRAKE_POSITION (17|10@BE+) |
0x00E | 14 | STEER_TORQUE | 8 | STEER_TORQUE (15|8@BE+), Counter (55|4), Checksum (63|8) |
0x045 | 69 | DRIVER_CONTROLS | 8 | Cruise stalk bits (bits 0–5: Cancel, Resume, Accel High/Low, Decel High/Low), Left/Right blinkers (bits 16–17), High beam toggle/flash (bits 18–19), Steering wheel buttons (32|16@LE+) |
0x06D | 109 | GEAR_LEVER | 8 | REVERSE (bit 8), NEUTRAL_UP (bit 9), NEUTRAL_DOWN (bit 10), DRIVE (bit 11), PARK_BUTTON (bit 12) |
0x073 | 115 | GEAR_PACKET | 8 | GEAR (0|4@LE+) |
0x101 | 257 | CRUISE_CONTROL | 8 | LONGITUDINAL_ACCEL_REQUEST (15|8@BE-), CRUISE_ACCELERATING (bit 22), CRUISE_DISABLED (bit 23) |
0x104 | 260 | CRUISE_CONTROL2 | 8 | Secondary cruise / Distronic frame with counter and checksum |
0x105 | 261 | GAS_PEDAL | 8 | ENGINE_RPM (4|5@BE+ scaled/compressed field), COMBINED_GAS (31|8@BE+), GAS_PEDAL (39|8@BE+) |
0x133 | 307 | POWER_SEATS | 8 | Driver seat forward/back switch bits (bits 0–1) |
0x201 | 513 | WHEEL_ENCODERS | 8 | Wheel tick encoders 1–4 (8-bit each: 7|8, 15|8, 23|8, 31|8) |
0x203 | 515 | WHEEL_SPEEDS | 8 | Wheel moving flags (bits 6, 22, 38, 54); 11b BE+ wheel speeds (×0.0375 mph): FL (2|11), FR (18|11), RL (34|11), RR (50|11) |
0x245 | 581 | IGNITION | 8 | Ignition / EIS terminal state |
0x283 | 643 | DOOR_SENSORS | 8 | Door open/closed bits FL/FR/RL/RR (bits 0–7), Brake pressed (bit 27) |
0x375 | 885 | SEATBELT_SENSORS | 8 | SEATBELT_DRIVER_LATCHED (bit 16), SEATBELT_PASSENGER_LATCHED (bit 18) |
0x378 | 888 | CRUISE_CONTROL3 | 8 | CRUISE_SET_SPEED (15|8@BE+, mph), CRUISE_ENABLED (bit 34), CRUISE_DISABLED (bit 36) |
Sources