Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Gearboxes
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

ZF describes its TraXon commercial-vehicle automated transmission as the successor to AS Tronic, and its 2022 service information describes a ConAct concentric pneumatic clutch-release cylinder in the TraXon systems covered there. The release unit sits around the transmission input shaft and differs from a conventional release fork. ConAct is also used by other vehicle manufacturers and is not an identification of a particular gearbox on its own. Confirm the VIN, transmission, clutch actuator, hardware and software before diagnosing a vehicle. ZF TraXon clutch-service information; ZF ConAct product description.

Operation and identification

In the documented ConAct arrangement, electronic control regulates pneumatic clutch release; the friction clutch remains a wearing mechanical part. A driver complaint at pull-away may involve the clutch, actuator, compressed-air supply, sensors, controls or engine behaviour. Compared with older fork-operated arrangements, physical access and release-component checks differ. Do not assume that a TraXon procedure or ConAct test applies to every AS Tronic gearbox.

Failed calibration and other symptoms

ZF service information 12409 EN, September 2021 states that the ConAct system it covers requires calibration using suitable diagnostic equipment after installation, following the vehicle manufacturer's instructions. It lists a display message, clutch grab and poor loaded manoeuvring among effects that can occur if this calibration has not been completed. These symptoms also have other possible causes; they are not proof that recalibration is the only repair.

For an unsuccessful calibration, that ZF note identifies insufficient vehicle compressed-air supply, restrictions in coarse or fine air filters, and the software version as possible checks. Its flowchart specifies a filter check and subsequent calibration sequence for the illustrated system. Follow the current vehicle and actuator instructions; a filter or air fault cannot be established merely from a failed learn-in, and calibration cannot repair a worn clutch or leak.

Practical diagnostic evidence

  1. Record the truck/bus, transmission and actuator identification, fault status, warning, repair history, load and conditions such as starting, first/reverse engagement, loaded manoeuvring or a specific shift. Save data before clearing or programming.
  2. Check the electrical and pneumatic supplies, relevant control faults and measured clutch command and feedback with the model-specific test plan. ZF's note specifically points to compressed air and filters when its ConAct calibration cannot complete; verify the applicable part and procedure first.
  3. Investigate friction clutch condition, release position and mechanical or control faults where evidence directs. A single warning or learned value does not measure remaining lining life or prove a controller defect.
  4. After the confirmed repair, carry out the specified configuration and calibration with compatible diagnostics and verify the original complaint under the appropriate conditions.

ZF warns that pneumatic pressure must be released according to the applicable service procedure before clutch, ConAct or gearbox removal work. Air can be retained and the mechanism can move; secure the vehicle and use the prescribed equipment rather than opening a line to test it. ZF clutch-service guidance.

Related: ZF AS Tronic DAF diagnosis, Volvo I-Shift and electronic gearbox index.