Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
Haltech standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Haltech E8 is a E series programmable engine-management model. Haltech's E8 specification describes fuel and ignition control for piston and rotary configurations, four injector outputs, four PWM outputs, three auxiliary analogue inputs and one auxiliary digital input. The number of outputs and supported strategy must be evaluated together. Manufacturer specification or guide.

Identification and output allocation

Record the full ECU label, serial number, hardware or harness revision, software and existing calibration. These characteristics are model-specific; a superficially similar E series ECU should not be treated as a drop-in replacement. Counts can be limited by shared outputs, external modules and the engine's ignition and injection strategy.

Model-specific pinout and wiring

Consult the E8 wiring documentation and the historic model manuals and connector archive where applicable. Select the named model and the precise harness revision; read its numbered connector view, driver characteristics, injector supply, power and ground notes. The connector appearance alone is not proof of identical pin functions.

Software and further information

legacy software matching the model. Haltech's download centre separates software and provides a legacy section. See Haltech standalone ECUs for the other families.

Manufacturer connector schedules

From Haltech's E8 main harness wiring diagram, revision A, 3 November 2008; the drawing shows the view looking into the ECU. “Not shown” means the position is not assigned on this harness drawing and does not assert it is electrically unconnected. Haltech's separately archived E11/E8 manual lists secondary pin 5 as N/C, while this E8 harness diagram shows it connected to ground. The manual also lists functions on positions the E8-specific diagram does not show. Confirm the installed hardware and loom with Haltech before using those conflicting positions.

34-way ECU connector

PinFunction shown on harness diagram
1PWM out 2
2Not shown
3Ignition 1
4Ignition 2
5Ignition 3
6Ignition 4
7Not shown
8Not shown
9+5 V sensor supply
10Ground
11ECU ground
12+8 V sensor supply
13Not shown
14TPS
15MAP
16Spare A/D 2 (trim)
17Spare A/D 3
18PWM out 1
19Injector 1
20Injector 2
21Injector 3
22Injector 4
23PWM out 3
24Fuel pump trigger
25Spare A/D 4
26+12 V switched ECU supply
27Not shown
28Not shown
29Aux out 1
30Not shown
31IDL 1
32IDL 2
33IDL 3
34IDL 4

26-way ECU connector

PinFunction shown on harness diagram
1Trigger
2Home
3Air temperature
4Coolant temperature
5Ground
6Not shown
7Aux input
8Not shown
9Not shown
10Timed input 3
11+12 V switched
12O2 sensor A
13Not shown
14Ground
15Ground
16Ground
17TX
18RX
19PWM out 4
20Not shown
21Not shown
22Not shown
23CAN high
24CAN low
25Not shown
26Not shown

J2 PC interface on the harness

PinFunction
1CAN high
2TX
3RX
5Ground
6CAN low

The other PC connector positions are not specified on the drawing.