Haltech E6X is a E series programmable engine-management model. Haltech's specification describes programmable fuel and ignition, eight injector drivers, four dedicated PWM outputs, staged and up-to-four-bank sequential injection, and distributor, direct-fire or wasted-spark modes within specified engine limits. Manufacturer specification or guide.
Identification and output allocation
Record the full ECU label, serial number, hardware or harness revision, software and existing calibration. These characteristics are model-specific; a superficially similar E series ECU should not be treated as a drop-in replacement. Counts can be limited by shared outputs, external modules and the engine's ignition and injection strategy.
Model-specific pinout and wiring
Consult the E6X wiring documentation and the historic model manuals and connector archive where applicable. Select the named model and the precise harness revision; read its numbered connector view, driver characteristics, injector supply, power and ground notes. The connector appearance alone is not proof of identical pin functions.
Software and further information
legacy software matching the model. Haltech's download centre separates software and provides a legacy section. See Haltech standalone ECUs for the other families.
Manufacturer connector schedule
These are the 36 positions from the Haltech E6X main harness wiring diagram. The diagram identifies the E6X main harness as revision A, 5 November 2008. It depicts a separate nine-way PC interface, with pins 2 TX, 3 RX and 5 ground. ECU power is shown at pins 7 and 25; consult the diagram for the fused supply and branching. This schedule is specific to the E6X; similarly numbered positions differ on the E6K and E6X. The diagram also documents the harness-side sensor, ignition, injector and relay connectors.
| ECU pin | Function | Harness colour where documented |
|---|---|---|
| 1 | Spare A/D | Red/black |
| 2 | O2 sensor | Grey, shielded |
| 3 | PWM out 2 | Pink/black |
| 4 | PWM out 1 | Violet/white |
| 5 | Road speed | Grey/yellow, shielded |
| 6 | Trigger | Yellow, shielded |
| 7 | +13 V DC ECU | See diagram |
| 8 | TX | Red in shielded cable |
| 9 | RX | Blue in shielded cable |
| 10 | Trim | Black/white |
| 11 | MAP | Yellow |
| 12 | Ignition 4 | Blue/yellow |
| 13 | Home | Green, shielded |
| 14 | IDL 4 | Brown/white |
| 15 | IDL 3 | Yellow/red |
| 16 | IDL 2 | Green/yellow |
| 17 | IDL 1 | Brown |
| 18 | +5 V sensor supply | Orange |
| 19 | Injector 1 | Light blue |
| 20 | Injector 2 | Blue/red |
| 21 | Injector 3 | Green/red |
| 22 | Injector 4 | Pink |
| 23 | PWM out 3 | Blue/green |
| 24 | PWM out 4 | Green/white |
| 25 | +13 V DC ECU | Red/white |
| 26 | Ground | Black |
| 27 | Auxiliary out | Green/black |
| 28 | Auxiliary in | Green |
| 29 | Air temperature | Grey |
| 30 | Coolant | Violet |
| 31 | Throttle position | White |
| 32 | ECU ground | See diagram |
| 33 | Pump relay trigger | Black/yellow |
| 34 | Ignition 3 / digital out 2 | Blue |
| 35 | Ignition 2 / digital out 1 | White/black |
| 36 | Ignition 1 | Light green |