Haltech E6K is a E series programmable engine-management model. Haltech's E6K specification describes programmable fuel and ignition, staged and up-to-four-bank sequential injection modes, eight injector drivers and four dedicated PWM outputs. Trigger inputs support several sensor types and patterns; ignition and injection resources must be allocated for the engine. Manufacturer specification or guide.
Identification and output allocation
Record the full ECU label, serial number, hardware or harness revision, software and existing calibration. These characteristics are model-specific; a superficially similar E series ECU should not be treated as a drop-in replacement. Counts can be limited by shared outputs, external modules and the engine's ignition and injection strategy.
Model-specific pinout and wiring
Consult the E6K wiring documentation and the historic model manuals and connector archive where applicable. Select the named model and the precise harness revision; read its numbered connector view, driver characteristics, injector supply, power and ground notes. The connector appearance alone is not proof of identical pin functions.
Software and further information
legacy software matching the model. Haltech's download centre separates software and provides a legacy section. See Haltech standalone ECUs for the other families.
Manufacturer connector schedule
These are the 36 positions from the Haltech E6K main harness wiring diagram. The diagram identifies the ECU connector as Packard 1211 0490 and the main harness as revision F, 15 December 2000. It depicts a separate nine-way PC interface, with pins 2 TX, 3 RX and 5 ground. This schedule is specific to the E6K; similarly numbered positions differ on the E6K and E6X. The diagram also documents the harness-side sensor, ignition, injector and relay connectors.
| ECU pin | Function | Harness colour where documented |
|---|---|---|
| 1 | Spare A/D | Red/black |
| 2 | O2 sensor | Grey, shielded |
| 3 | PWM out 2 | Pink/black |
| 4 | PWM out 1 | Violet/white |
| 5 | Road speed | Grey/yellow, shielded |
| 6 | Trigger | Yellow, shielded |
| 7 | Input B | Red, shielded |
| 8 | TX | Red, shielded |
| 9 | RX | Blue, shielded |
| 10 | Trim | Black/white |
| 11 | MAP | Yellow |
| 12 | Input A | Blue, shielded |
| 13 | Home | Green, shielded |
| 14 | IDL 4 | Brown/white |
| 15 | IDL 3 | Yellow/red |
| 16 | IDL 2 | Green/yellow |
| 17 | IDL 1 | Brown |
| 18 | +5 V DC | Orange |
| 19 | Injector 1 | Light blue |
| 20 | Injector 2 | Blue/red |
| 21 | Injector 3 | Green/red |
| 22 | Injector 4 | Pink |
| 23 | PWM out 3 | Blue/green |
| 24 | PWM out 4 | Green/white |
| 25 | +13 V DC ECU | Red/white |
| 26 | Ground | Black |
| 27 | Auxiliary out | Green/black |
| 28 | Auxiliary in | Green |
| 29 | Air temperature | Grey |
| 30 | Coolant | Violet |
| 31 | Throttle position | White |
| 32 | Ground | Black |
| 33 | Pump relay | Black/yellow |
| 34 | Digital out 2 | Blue |
| 35 | Digital out 1 | White/black |
| 36 | Ignition out | Light green |