The 200 is an ignition-only ECU rather than a full fuel-injection controller. Its installation manual identifies two amplified ignition outputs for single-coil/distributor or wasted-spark configurations. It describes inputs for crank position, throttle, temperature and MAP, as well as relay-controlled fuel pump and fan functions. Individual hardware modifications may be necessary for particular coil-on-plug arrangements. Model-specific Omex manual · Omex engine-management range.
Connector and pinout
The exact loom-side connector table and diagrams are in section 4.3 of Omex installation manual 2v10. The guide identifies FTG input at 10A; do not transfer the 600 pinout to a 200. Open the exact-model installation or hardware manual.
Software and setup
Omex lists MAP4000 for its current ECU range; check the exact unit, firmware and communications lead before attempting to connect. Record ECU serial and firmware, save the existing calibration, and confirm crank trigger, injector, coil, sensors and assigned outputs against the matching manual. Manufacturer startup calibrations require verification and adjustment for the actual engine.
Compare models and historical identities in the Omex family guide.
Omex 200 main connector pinout
From the Omex OMEM200 installation manual 2v10, pages 22–23. Connector orientation is from the wiring-loom side, with rows A to C and positions 1 to 12. Blank cells in the manufacturer table are shown as “not specified”; they must not be assumed electrically unused. Two-colour wire main and tracer colours may be reversed. Confirm the specific loom and ECU configuration.
| Pin | Wire colour | Function |
|---|---|---|
| 1A | Violet | Ignition 1 |
| 2A | Not specified | Not specified |
| 3A | Not specified | Not specified |
| 4A | Red | Battery power |
| 5A | Black | Chassis earth 1 |
| 6A | Grey | Sensor ground |
| 7A | Black screened red | Crank sensor |
| 8A | Blue screened-cable conductors | Timing ground |
| 9A | White/violet | Coolant temperature sensor |
| 10A | White/yellow | Full-throttle gearshift input |
| 11A | Not specified | Not specified |
| 12A | Yellow | Ignition 2 |
| 1B | Not specified | Not specified |
| 2B | Not specified | Not specified |
| 3B | Not specified | Not specified |
| 4B | Not specified | Not specified |
| 5B | Blue/white | Fuel pump |
| 6B | Green | MAP sensor |
| 7B | Black | Chassis earth 2 |
| 8B | Blue/grey | Shift light |
| 9B | Green/white | Air temperature sensor |
| 10B | Not specified | Not specified |
| 11B | White/orange | Alt mode input |
| 12B | Yellow/red | Radiator fan 2 (bay fan) |
| 1C | Not specified | Not specified |
| 2C | Not specified | Not specified |
| 3C | Not specified | Not specified |
| 4C | Yellow/black | VTEC |
| 5C | Not specified | Not specified |
| 6C | Blue/black | Radiator fan |
| 7C | Not specified | Not specified |
| 8C | Orange | Throttle position sensor |
| 9C | Pink | 5 V out |
| 10C | Not specified | Not specified |
| 11C | Not specified | Not specified |
| 12C | Blue/yellow | Tacho |
The manual's table calls 4A battery power, while its typical-wiring diagram labels the red supply ignition 12 V; resolve the intended supply for the specific installation with Omex before wiring. The source identifies 10A as a switch-to-earth full-throttle gearshift input, and 11B as a +12 V alt-mode input. Refer to the complete manual for the exact sensor, relay and coil wiring.