Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
DTAFast standalone engine management
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

DTAFast E6 is a historic programmable engine-management identity documented in the manufacturer's model wiring schematic. The 14 February 1997 DTA six-cylinder power schematic shows three ignition coil outputs, an injector output and a second output shared with idle-valve use, plus relay outputs.

Identification

Identify the actual case label, harness connectors, output configuration and firmware. An old loom may have been modified for a particular engine. No current product availability or universal support status is inferred from this historical schematic.

Model-specific pinout and wiring

The manufacturer E6 drawing supplies connector views, functions, sensor/actuator examples and grounding. The separate E4/E6/E8 sensor schematic must be used alongside the power schematic. Both battery earth connections are called out in the period power drawing. Match connectors and diagram orientation to the actual ECU; do not transfer pin assignments from another E- or S-series model.

Power connector assignments in the 1997 drawing

The following positions are traced from the DTAFast E6 power schematic dated 14 February 1997, which labels the view as the female loom power connector. “Not shown” means the drawing does not identify a connection; it does not establish that a cavity is unused in every build. Connect both specified power grounds and use the manufacturer diagram and correct fuses and relay arrangements.

PinFunction shown
AIgnition-switched supply
BBattery negative / ground
CBattery negative / ground
DCoil 1, earth side
ECoil 2, earth side
FInjector bank 1
GInjector bank 1
HInjector bank 2 or idle valve
JInjector bank 2 or idle valve
KGear-change light, 20 W maximum
LCoil 3, earth side
MNot shown in this power schematic
NTachometer output
PAuxiliary 1: fuel-pump relay
RAuxiliary 2: relay earth side
SNot shown in this power schematic
TNot shown in this power schematic
UNot shown in this power schematic

Separate sensor connector

The source draws a separate male loom sensor connector. Its E4/E6/E8 sensor diagram specifies, among other connections, M and N for the Vauxhall crank sensor, with sensor pin 1 to M and pin 2 to N; screened cable shields join N. The guide says the Marelli sensor polarity differs from Ford. R goes to the earthed side of the lambda sensor. Obtain the exact diagram and connector view for all other sensor cavities; this power-connector table is not a complete sensor pinout.

Related documentation

DTAFast's wiring archive includes crank sensor rules and legacy ECU sheets. Confirm support, software and hardware serviceability directly with DTAFast. See the DTAFast family overview.